We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White extension cord with US plug, inline switch and three-pin LED tube connector

TAURKENAM

TAURKENAM T5 T8 LED Extension Cord Power Adapter 3m 3-pin 100-120W 110-250V

SKU CH-F9A8-ZPMY8

Three-metre US-plug extension cord with a three-pin T5/T8 connector and built-in on/off switch powers integrated LED tubes up to 120 W across 110-250 V

  • Power LED tubes directly from any US wall outlet with a three-pin T5/T8 connector
  • Built-in on/off switch lets you control fixtures without reaching the wall socket
  • Tool-free installation connects integrated T5 or T8 lights in seconds
  • CCC-listed cord rated for 100-120W across 110-250V input
  • 10 ft length reaches distant outlets in bedrooms, basements, closets or studios

US plug to three-pin T5/T8 connector

This three-metre extension cord carries a US AC plug on one end and a three-pin connector that fits integrated T5 and T8 LED tubes on the other. It lets you power linear fixtures directly from a standard wall outlet without hard-wiring. The built-in on/off switch puts control at the cord instead of at the fixture. Installation requires no tools and suits bedrooms, basements, closets or studios where the power source is out of reach.

Replaces fixed wiring or short factory leads

The cord replaces a permanent electrical connection or the short lead that ships with many integrated tubes, giving freedom to position the light where the outlet is not. The upgrade is worth it when the fixture must be mounted farther than its original cable allows or when a switch on the cord is more convenient than a wall switch. It supports loads up to 120 W across a 110 V to 250 V range, so it covers most residential and light-commercial circuits.

CCC-listed cable with inline switch under

The assembly carries CCC listing and uses an American AC plug rated for the stated voltage and wattage band. Under sustained operation the inline switch and three-pin connector remain the control points, with no additional thermal management features described. The cord is intended for indoor dry locations only and is not suited for outdoor, damp or high-temperature environments where a fixed installation would be required.

Highlights

  • Power LED tubes directly from any US wall outlet with a three-pin T5/T8 connector
  • Built-in on/off switch lets you control fixtures without reaching the wall socket
  • Tool-free installation connects integrated T5 or T8 lights in seconds
  • CCC-listed cord rated for 100-120W across 110-250V input
  • 10 ft length reaches distant outlets in bedrooms, basements, closets or studios

Specifications

No published specifications for this item yet.

Questions about this item

What connector does the adapter use to attach to a T5 or T8 LED tube?

The adapter ends in a three-pin connector that plugs directly into the integrated fixture without any tools.

How is the power cord installed, and what step do people often miss?

Plug the US AC plug into a 110V-250V outlet, connect the three-pin end to the fixture, then use the built-in ON/OFF switch on the cable to control the light — forgetting the switch leaves the fixture permanently live.

When should the extension cord be replaced?

Replace the cord if the plug, switch or three-pin connector shows heat damage, cracking or intermittent operation, since the assembly is rated for 100-120W maximum load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.