We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A compact white rectangular PoE injector with two Ethernet ports and an integrated power plug

TAURKENAM

TAURKENAM 48 V 15 W Passive PoE Injector 10/100/1000 Gigabit

SKU CH-MT6P-ZBJMH

Adds 48 V, 15 W passive PoE over Gigabit Ethernet up to 328 ft for IP cameras, VoIP phones and Wi‑Fi access points

  • TypeAccessories
  • Adds PoE to any switch up to 328 ft via Ethernet cable
  • Powers 802.3af devices at 48 V 15 W passive PoE always on
  • Works with IP cameras VoIP phones WiFi APs splitters
  • Gigabit 10 100 1000 data pass through with no signal loss
  • Plug and play single port injector Data In Data Power Out

Single-port 48 V 15 W injector

This passive PoE injector adds 48 volt, 15 watt power to a single Ethernet line so non-PoE switches can feed IP cameras, VoIP phones or wireless access points. It transmits 10/100/1000 Gigabit data while delivering power up to 328 feet over standard cable.

Plug-and-play with one Data In

Connect the injector between the switch and the powered device using two patch cords; no software or configuration is required. The unit is always-on, so it supplies voltage even if the attached device does not negotiate 802.3 af, which can damage non-PoE gear if plugged into the output port by mistake.

Check that the end device accepts 48 V passive PoE

Verify the powered equipment is rated for 802.3 af and 15 watts or less before ordering. Ensure the cable run does not exceed 328 feet and that the source switch port is a standard data port, not an existing PoE port, to avoid voltage conflicts.

Highlights

  • Adds PoE to any switch up to 328 ft via Ethernet cable
  • Powers 802.3af devices at 48 V 15 W passive PoE always on
  • Works with IP cameras VoIP phones WiFi APs splitters
  • Gigabit 10 100 1000 data pass through with no signal loss
  • Plug and play single port injector Data In Data Power Out

Specifications

TypeAccessories

Questions about this item

How do I confirm the injector is delivering 48 V 15 W to my access point after plugging it in?

The passive injector provides Always On power. Verify the linked device powers up and negotiates a 10/100/1000 Gigabit link. If the device reports 802.3 af operation and runs stably at up to 328 feet, the injector is working as intended.

What cables or power cords come in the box and what must I supply?

The unit has an integrated 48 V power supply with a Data In port and a Data + Power Out port. You supply two Ethernet cables — one from your switch to Data In, one from Data + Power Out to the PoE device. No separate power cord is required.

Should I choose a different voltage or wattage model for an 802.3 af camera?

This single model delivers exactly 48 V and 15 W, which matches the 802.3 af specification. There are no other voltage or capacity versions listed, so this injector is the correct choice for any device labeled 802.3 af.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.