We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow contractor-grade extension cord with inline GFCI module and lighted receptacle end

TAURKENAM

TAURKENAM 2817 12/3 SJTOW GFCI Extension Cord 120V 15A 1800W

SKU CH-F921-MT5ZQ

A 12-gauge extension cord with an in-line GFCI and lighted receptacle provides 120-volt, 15-amp, 1800-watt protection for indoor and outdoor tools

  • GFCI protection for indoor and outdoor use
  • 12/3 SJTOW cord with lighted receptacle for visibility
  • Manual reset prevents unmonitored equipment startup
  • Rated 120V 15A 1800W for power tools
  • cULus listed safety compliance for job sites

Indoor and outdoor GFCI cord set

This 12/3 SJTOW cord set provides ground-fault protection for power tools, saws, drills and lighting both indoors and outdoors. It carries a NEMA 5-15 plug and a lighted receptacle rated at 120 volts, 15 amps and 1800 watts. The in-line GFCI trips at 4 to 6 mA and requires a manual reset after any trip or power loss.

Sustained load with manual reset

Under continuous use the cord delivers its full 15-amp rating while the GFCI monitors for leakage current. If a fault occurs the device trips and will not re-energise the receptacle until the user presses the reset button. This behaviour prevents unmonitored equipment restart after an outage or a ground-fault event.

Simple plug-in installation

Installation consists of plugging the NEMA 5-15 plug into a standard outlet and connecting the tool or light to the lighted receptacle. The only common issue is forgetting to press the reset button after a trip or power cut, which leaves the downstream equipment without power until manually restored.

Highlights

  • GFCI protection for indoor and outdoor use
  • 12/3 SJTOW cord with lighted receptacle for visibility
  • Manual reset prevents unmonitored equipment startup
  • Rated 120V 15A 1800W for power tools
  • cULus listed safety compliance for job sites

Specifications

No published specifications for this item yet.

Questions about this item

Does the in-line GFCI on the TAURKENAM 2817 generate noticeable heat or noise when powering a 15 A load all day?

The unit carries a 15 A rating at 120 V and a 4–6 mA trip level; it has no fan or active electronics, so it runs silently and stays cool under continuous 1800 W use.

What must I already own to plug this cord set into a jobsite outlet and start using it?

A standard NEMA 5-15 wall receptacle supplies the 120 V feed; the cord’s own NEMA 5-15 plug and lighted receptacle accept any 120 V tool or light without extra adapters.

Will the manual-reset GFCI on this 12/3 SJTOW cord interfere with older power tools that lack built-in ground-fault protection?

The GFCI trips at 4–6 mA and requires a manual reset after any trip or power loss, so legacy tools operate normally but gain ground-fault protection they did not have before.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.