We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black 87mm graphics card cooling fan with four-pin connector

SXDOOL

SXDOOL PLA09215B12H 87mm graphics card cooler 12V .55A 42mm mount

SKU CH-NNS1-CM3E4 MPN PLA09215B12H

Replaces the original fan on compatible MSI graphics cards with an 87mm double ball bearing unit using a 42mm mount, 12V .55A four-wire interface

  • 87mm fan fits select MSI N560, N570, N580GTX, HD6870, R7770, N550GTX-Ti Cyclone II and Blizzard 1G models
  • Double ball bearing design reduces wear for longer operational life
  • 12V .55A power draw keeps electrical load low on the graphics card
  • 42mm mounting hole pattern matches the reference board layout for direct replacement
  • Four-wire graphics card interface enables PWM speed control and RPM monitoring

Compatible GPU cooler for MSI models

This 87 mm replacement fan fits MSI N560, 570, 580GTX, HD6870, R7770 Power Edition, N550GTX-Ti Cyclone II and N550GTX-Ti-Blizzard 1G cards. It uses a double ball bearing motor rated at 12 V and 0.55 A. The unit is supplied new and ready for installation.

Mounting constraint and power interface

The cooler requires a 42 mm square hole pattern on the graphics card heatsink. Its four-wire connector must match the card’s fan header pin-out; polarity or signal mismatches will prevent speed control or stop the fan entirely. Verify both dimensions and connector layout before purchase.

Straightforward swap with common pitfalls

Installation involves removing the original shroud, aligning the 42 mm screw holes and plugging in the four-line cable. Problems usually arise when the mounting posts differ slightly or the header keying is reversed, leading to vibration or a non-spinning fan. Double-check fitment against the listed models.

Highlights

  • 87mm fan fits select MSI N560, N570, N580GTX, HD6870, R7770, N550GTX-Ti Cyclone II and Blizzard 1G models
  • Double ball bearing design reduces wear for longer operational life
  • 12V .55A power draw keeps electrical load low on the graphics card
  • 42mm mounting hole pattern matches the reference board layout for direct replacement
  • Four-wire graphics card interface enables PWM speed control and RPM monitoring

Specifications

No published specifications for this item yet.

Questions about this item

Which MSI graphics cards does the 87mm PLA09215B12H cooler fit?

It matches N560, 570, 580GTX, HD6870, R7770 Power Edition, N550GTX-Ti Cyclone II 1GD5/OC and N550GTX-Ti-Blizzard 1G models

What does the 0.55A current draw mean for my graphics card?

The fan pulls 0.55A at 12V, so the card's fan header must supply at least that much current for reliable operation

What does the 42mm hole spacing and 4-line interface cap in practice?

The 42mm mounting pattern and four-wire connector limit installation to cards with that exact screw layout and PWM control header

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.