We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey aluminium M.2 2280 heatsink with angled fins and thermal pad, 73x24.4x9.6mm

SXDOOL

SXDOOL M.2 2280 SSD Aluminium Heat Sink with Thermal Pad 73x24.4x9.6mm

SKU CH-019K-AZ0NA

Aluminium heat sink with thermal pad cools single-sided M.2 2280 NVMe SSDs using a 45° fin design

  • TypeCase Fan Accessory
  • All-aluminium fin design with 45° angled channels moves chassis airflow across the SSD
  • 73×24.4×9.6 mm footprint fits single-sided M.2 2280 drives without clearance issues
  • Built-in thermal silicone pad conducts heat from controller and NAND to the aluminium body
  • Anodised sand-blasted surface resists corrosion and stays clean during handling
  • Bottom stripe fins add a second dissipation path for faster heat removal

Fits M.2 2280 single-sided drives

This aluminium heat sink is made for M.2 2280 solid-state drives that have chips on one side only. It adds passive cooling to desktop PCs where an NVMe drive runs hot. The 73x24.4x9.6mm footprint keeps clearance tight for small builds.

Replaces bare operation or thin stickers

The finned block with its included thermal pad draws heat from the controller and NAND far better than a factory label or no spreader at all. The upgrade is worth it when sustained writes throttle the drive or when the motherboard lacks an integrated M.2 shield.

Passive fins work with case airflow

The 45° inclined fins align with typical chassis air paths so moving air pulls heat from both top and bottom surfaces. Anodised sandblasted aluminium resists corrosion while the silicone pad maintains contact through thermal cycles. No fan or power connection is required.

Highlights

  • All-aluminium fin design with 45° angled channels moves chassis airflow across the SSD
  • 73×24.4×9.6 mm footprint fits single-sided M.2 2280 drives without clearance issues
  • Built-in thermal silicone pad conducts heat from controller and NAND to the aluminium body
  • Anodised sand-blasted surface resists corrosion and stays clean during handling
  • Bottom stripe fins add a second dissipation path for faster heat removal

Specifications

TypeCase Fan Accessory

Questions about this item

Will the 73 x 24.4 x 9.6 mm aluminium heatsink clear my motherboard’s M.2 slot and nearby components?

The heatsink measures 73 mm long, 24.4 mm wide and 9.6 mm tall, so verify that your board has at least that much clearance around the M.2 2280 slot before fitting it.

How do I attach the heatsink to a single-sided M.2 2280 drive without trapping air bubbles?

Peel the protective film from the pre-applied thermal pad, align the heatsink over the controller and NAND chips, then press down evenly across the fin array so the pad makes full contact.

Does the anode-sandblasted aluminium finish need any upkeep to keep its thermal performance?

The corrosion-resistant coating requires no maintenance; simply blow dust out of the fins with compressed air if airflow becomes restricted.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.