Superwinch
Superwinch 87-12894 Rocker Switch for LT3000/4000 Winches
Replacement rocker switch controls Superwinch LT3000 and LT4000 winches
- Direct replacement for LT3000 and LT4000 winches
- Factory-sourced Superwinch component for reliable operation
- New condition ensures full service life
- Simple rocker design for straightforward control
- California Proposition 65 chemical warning applies
Replacement Rocker Switch
This replacement rocker switch is designed for LT3000 and LT4000 winches. It provides a direct-fit control for operating the winch from the vehicle cab. The part restores original switch function when the factory unit is damaged or worn. Installers can connect it using the existing wiring harness.
Sustained Operation
The switch handles the current draw required by LT3000 and LT4000 winches during extended pulls. Contacts are rated for the motor load these winches present under continuous duty. Heat buildup during long recoveries stays within the component limits. No additional relays or wiring upgrades are needed for standard installations.
Interface Limits
The switch uses the factory connector and voltage supplied by the winch solenoid pack. It does not add illumination, wireless control or variable-speed functions. California Proposition 65 warnings apply because the component contains listed chemicals. Buyers who need a sealed waterproof switch or a handheld remote should look for a different control kit.
Highlights
- Direct replacement for LT3000 and LT4000 winches
- Factory-sourced Superwinch component for reliable operation
- New condition ensures full service life
- Simple rocker design for straightforward control
- California Proposition 65 chemical warning applies
Specifications
| Brand | SUPERWINCH |
|---|
Questions about this item
Does the rocker switch draw noticeable power when the LT3000 winch runs all day?
The switch only carries the control signal; the winch motor draws the working current, so the switch itself adds negligible load.
What wiring or connector must already be on the vehicle for this 87-12894 switch to plug in?
It replaces the factory rocker on LT3000 and LT4000 winches, so the existing two-wire harness and dash cut-out are all that is required.
Will the switch fit the original dash panel on an older LT3000 winch?
Yes, it is a direct replacement rocker for both LT3000 and LT4000 models, matching the original mounting dimensions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
