Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00933619BTC
In stock
Streamline
Streamline A 01570NL Copper Tee 1" Cup × 1" Cup × 1/2" FNPT
Copper tee joins two 1" sweat connections with a 1/2" female pipe thread branch for potable water
- ColorTransparent
- TypePipes, Valves & Fittings
- Copper construction resists corrosion for long service life
- Sweat cup ends join 1 in tube with standard tools
- 1/2 in FNPT branch accepts threaded fittings directly
- Precleaned surface speeds up soldering preparation
- Lead-free alloy approved for potable water systems
Copper tee for potable water systems
This cast-copper sweat fitting joins two 1-inch copper tubes with a 1/2-inch female NPT branch. It is intended for installers running potable-water lines who need a durable, lead-free tee that meets plumbing codes.
Sweated joints on the run and threaded branch
The two cup ends accept 1-inch copper tube for soldered connections while the 1/2-inch FNPT outlet accepts standard pipe-thread fittings or valves. This layout lets you add a take-off without extra adapters, keeping the joint count low.
Pre-cleaned surface and center-stop-free bore
The fitting arrives pre-cleaned so flux can be applied immediately, and the open bore avoids flow restriction at the branch. No additional sealants or gaskets are included, so installers supply their own solder, flux and thread tape.
Highlights
- Copper construction resists corrosion for long service life
- Sweat cup ends join 1 in tube with standard tools
- 1/2 in FNPT branch accepts threaded fittings directly
- Precleaned surface speeds up soldering preparation
- Lead-free alloy approved for potable water systems
Specifications
| Brand | STREAMLINE |
|---|---|
| Color | Transparent |
| Type | Pipes, Valves & Fittings |
Questions about this item
How does the 1/2" FNPT branch affect flow when the tee runs at full capacity?
The 1/2" FNPT outlet creates a smaller passage than the 1" copper runs, so flow through that branch will be restricted compared with the straight-through ports.
Will the cast copper body stay quiet and cool in a constantly circulating hot-water loop?
Cast copper conducts heat well and has no moving parts, so the fitting itself adds no noise and reaches equilibrium with the water temperature.
What copper tubing must be on hand to sweat the two 1" cup ends?
You need 1" Type K, L, or M copper tube with a 1" outer diameter for the two cup connections.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
