Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00931552BTC
In stock
Stiebel Eltron
Stiebel Eltron Mini-E 2.5-1 electric tankless water heater
Compact undersink electric tankless heater delivering 0.5 gpm at 120 V with adjustable thermostat from 86 to 122 °F
- TypeWater Heaters
- Delivers instant hot water at 0.5 gpm maximum flow
- Activates at just 0.3 gpm for low-demand fixtures
- Adjustable thermostat sets temperature between 86 and 122°F
- Compact 7.5 × 6.5 × 3.25 in fits under any sink
- Runs on standard 120 V AC with 20 A draw
Undersink electric tankless water heater
The Stiebel Eltron Mini-E 2.5-1 is a compact electric tankless water heater designed for undersink installation. It suits commercial and industrial indoor environments where a small point-of-use hot water source is required. The unit operates on a 120V AC single-phase supply and draws 20 A.
0.5 gpm maximum flow with 2.4 kW heating
The heater delivers a maximum flow rate of 0.5 gpm and activates at a minimum flow of 0.3 gpm. It provides adjustable output temperatures between 86 and 122 degrees F. The 2,400 W element supplies enough power for low-demand fixtures but will not support higher flow rates or multiple outlets.
120V connection with compression inlet
A 12/2 AWG cord connects the heater to a 120V circuit. The cold water inlet uses a 3/8 in compression fitting. At 7.5 in wide, 6.5 in high and 3.25 in deep, the unit fits beneath most sinks, freeing floor space that a storage tank would occupy.
Highlights
- Delivers instant hot water at 0.5 gpm maximum flow
- Activates at just 0.3 gpm for low-demand fixtures
- Adjustable thermostat sets temperature between 86 and 122°F
- Compact 7.5 × 6.5 × 3.25 in fits under any sink
- Runs on standard 120 V AC with 20 A draw
Specifications
| Brand | STIEBEL ELTRON |
|---|---|
| Type | Water Heaters |
Questions about this item
Will the 120 V 20 A supply I already have in the kitchen run this 2.5 kW heater without tripping the breaker?
The unit draws 20 A at 120 V for 2 400 W, so a dedicated 20 A circuit is required; sharing the circuit with other loads will likely trip the breaker.
How do I confirm the heater is delivering water between 86 °F and 122 °F once it is installed?
Open a hot tap until flow exceeds 0.3 gpm, let the temperature stabilise, then check with a thermometer; the adjustable thermostat should hold the output within the 86–122 °F range.
Does the box include the 3/8 in compression fittings and 12/2 AWG cord, or must I buy them separately?
The heater ships with a factory-attached 12/2 AWG cord and a 3/8 in compression cold inlet; no additional fittings or cord are needed for a standard undersink installation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
