Stiebel Eltron
Stiebel Eltron DHC 6-3 Classic 277V water heater part
An electric tankless water heater operating at 277 V AC, single phase, with a 6,000 W power draw and 22 A current
- TypeWater Heaters
- Delivers hot water on demand with 6,000 W heating power
- Activates at just 0.48 gpm minimum flow rate
- Draws 22 A at 277 V single-phase supply
- Compact 14.19 × 7.94 × 3.88 in fits tight indoor spaces
- Provides 82–130 °F output without adjustable thermostat
277 V tankless heater for commercial indoor use
This Stiebel Eltron DHC 6-3 Classic unit is a new electric tankless water heater rated for 277 V AC single-phase supply. It is intended for commercial indoor installations where a compact footprint is required. The heater activates at a minimum flow of .48 gpm through a 1/2 in female NPT cold inlet.
Steady output at 6 kW continuous draw
Under sustained demand the heater delivers up to 130 Degrees F and draws 22 A at its 6,000 W rating. Because the thermostat is not adjustable, the outlet temperature is fixed by the incoming water temperature and flow rate. The minimum delivered temperature is 82 Degrees F when conditions allow.
Verify voltage, phase and inlet before ordering
Confirm that the site provides 277 V AC single-phase power and a 1/2 in female NPT cold-water connection. The unit measures 14.19 in high, 7.94 in wide and 3.88 in deep, so check that the mounting location accommodates these dimensions. California Proposition 65 warnings apply to this product.
Highlights
- Delivers hot water on demand with 6,000 W heating power
- Activates at just 0.48 gpm minimum flow rate
- Draws 22 A at 277 V single-phase supply
- Compact 14.19 × 7.94 × 3.88 in fits tight indoor spaces
- Provides 82–130 °F output without adjustable thermostat
Specifications
| Brand | STIEBEL ELTRON |
|---|---|
| Type | Water Heaters |
Questions about this item
How much current does the 277 V heater draw when running continuously?
The unit draws 22 A at full power, so the circuit must be sized for that load during all-day use.
What inlet fitting does the 1/2 in NPT cold connection require?
It needs a 1/2 in male NPT thread on the supply line to mate with the female inlet on the heater.
Will the 0.48 gpm activation threshold work with older low-flow fixtures?
Yes, the heater activates at 0.48 gpm, which is low enough for many vintage faucets and shower heads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



