Steelman
Steelman 50041-WMQ-IND 25-Foot Coiled 3/8" ID Air Hose
A 25-foot coiled 3/8-inch ID polyurethane air hose with reusable 1/4-inch NPT brass fittings, kink-resistant and rated to 100 PSI
- Coiled design extends 25 feet for wide reach
- 3/8-inch ID delivers high airflow to pneumatic tools
- Premium polyurethane resists abrasion better than rubber or nylon
- Kink and crush resistant for reliable shop use
- Reusable 1/4-inch NPT brass fittings connect quickly to compressors
Coiled 3/8-Inch ID Polyurethane Air Hose
The STEELMAN 50041-WMQ-IND is a 25-foot coiled hose with a 3/8-inch inner diameter built from premium abrasion-resistant polyurethane. It comes fitted with reusable 1/4-inch NPT brass and quick-connect fittings for immediate connection to compressors and pneumatic tools. The tubing is 25 percent lighter than equivalent rubber hoses, reducing operator fatigue during extended use. Its coiled design retracts automatically to keep work areas clear of trip hazards.
Suited for mobile pneumatic work.
Technicians who move between service bays or job sites benefit from the lightweight, kink-resistant coil that withstands twisting and crushing on concrete floors. The 100 PSI working pressure rating covers common impact wrenches, ratchets, and spray guns in automotive and industrial settings. Users requiring permanent plumbed installations or flow rates exceeding the 3/8-inch bore capacity should consider rigid piping systems instead. The Proposition 65 notice also means buyers in regulated environments must verify material compliance.
100 PSI maximum working pressure
The hose is rated for compressed air pressures up to 100 PSI, which determines whether it matches the output of a specific compressor and the demand of connected tools. Exceeding this limit risks hose failure and safety hazards, so the rating is the primary specification to check against system requirements. The reusable brass fittings accept standard 1/4-inch NPT quick connects and adapters without additional tooling. California Proposition 65 warnings apply to chemicals in the product materials.
Highlights
- Coiled design extends 25 feet for wide reach
- 3/8-inch ID delivers high airflow to pneumatic tools
- Premium polyurethane resists abrasion better than rubber or nylon
- Kink and crush resistant for reliable shop use
- Reusable 1/4-inch NPT brass fittings connect quickly to compressors
Specifications
| Brand | STEELMAN |
|---|
Questions about this item
How do I install the Steelman 50041-WMQ-IND 25-Foot Coiled Air Hose and what step is commonly missed?
Connect the pre-attached reusable brass fittings to your 1/4-inch NPT compressor outlet and tool quick-connects; the step often missed is tightening the fittings securely with a wrench to prevent air leaks at 100 PSI working pressure.
What maintenance or replacement will the Steelman 50041-WMQ-IND hose need over time?
Inspect the polyurethane tubing regularly for abrasion cuts or crushing damage, especially on concrete floors, and replace the hose if the coils lose memory or fittings show corrosion; the brass ends are reusable for new tubing.
What limit appears first during sustained use of the Steelman 50041-WMQ-IND at full pressure?
The 100 PSI maximum working pressure is the primary limit; sustained operation at this pressure can accelerate wear on the polyurethane coils and brass fitting seals, reducing hose flexibility and seal integrity over time.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
