Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.0091554BTC
In stock
SQUARE D
SQUARE D 9013FH Pressure Switch 80-100 PSI 1Port
Controls air-compressor pressure from 80 to 100 psi with a 20 psi differential and DPST contacts rated for up to 5 hp at 240 V three-phase
- TypeLight Switch
- Auto/Off control for compressor convenience
- Factory set 80/100 psi on/off pressure
- 20 psi differential keeps cycling stable
- DPST contacts handle 120 V 2 hp or 240 V 3 hp
- NEMA 1 rated from -22 to 257 °F
Square D 9013FH Pressure Switch
The Square D 9013FH is a pressure switch built for air compressor systems that need automatic on and off control. It suits installers and maintenance teams who want a direct-acting switch with a factory-set 80 to 100 psi range.
Sustained operation with standard action
The switch uses a standard action mechanism rated for continuous cycling between the 80 psi cut-in and 100 psi cut-out points. A 20 psi differential keeps the compressor from short-cycling during extended runs. The NEMA 1 enclosure and a temperature range of -22 to 257 degrees Fahrenheit support indoor use in typical shop environments.
DPST contacts and motor ratings decide fit
Double-pole single-throw contacts handle 2 hp at 120 V single phase, 3 hp at 240 V single phase, 5 hp at 240 V three phase and 1 hp at 480 V three phase. The 1/4 inch FNPS port connects directly to the compressor tank. Buyers who need an unloader valve, a different pressure range or a higher NEMA rating should look elsewhere.
Highlights
- Auto/Off control for compressor convenience
- Factory set 80/100 psi on/off pressure
- 20 psi differential keeps cycling stable
- DPST contacts handle 120 V 2 hp or 240 V 3 hp
- NEMA 1 rated from -22 to 257 °F
Specifications
| Brand | Square D |
|---|---|
| Type | Light Switch |
Questions about this item
How much heat can the 9013FH switch handle during continuous operation?
The switch operates from -22 to 257 degrees F, so it tolerates high ambient temperatures during all-day use.
What pipe fitting do I need to connect this switch to my compressor?
It has a single 1/4 inch FNPS port, so you need a matching 1/4 inch MNPS fitting on your air line.
Will the DPST contacts control my existing 240 V single-phase motor?
Yes, the switch is rated for 3 hp at 240 V single-phase, suitable for many compressor motors.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
