We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square D 9007C limit switch lever arm, 3 in zinc arm with .63 in nylon roller, .25 in wide, .31 in deep

SQUARE D

SQUARE D 9007C Limit Switch Lever Arm 3 in .63 dia .25 w .31 d

SKU CH-6XGA-Y1VWR

A 3 in zinc lever arm with a 0.63 in nylon roller fits Square D 9007AW limit switches

  • TypeLight Switch
  • Standard roller actuator ensures reliable switching
  • 3 in arm length provides extended reach
  • 63 in nylon roller reduces wear
  • Zinc arm construction resists corrosion
  • Compatible with 9007AW limit switches

Lever Arm for 9007AW Switches

This zinc limit-switch lever arm is designed as a direct actuator for Square D 9007AW type limit switches. It provides the mechanical link between moving equipment and the switch body in industrial control circuits.

Standard Roller Actuator Dimensions

The arm measures three inches in length with a tapered width and a depth of .31 inches. A nylon roller of .63 inch diameter and .25 inch width sits in an outside-offset position to suit the switch cam profile.

Replaces Worn 9007C Arms

Use this arm when the original lever has bent, the roller has flattened or the pivot shows excessive play. The jump is worth it when switch actuation becomes unreliable or when preventive maintenance calls for a fresh nylon roller surface.

Highlights

  • Standard roller actuator ensures reliable switching
  • 3 in arm length provides extended reach
  • 63 in nylon roller reduces wear
  • Zinc arm construction resists corrosion
  • Compatible with 9007AW limit switches

Specifications

BrandSquare D
TypeLight Switch

Questions about this item

How do I install the 9007C lever arm on the switch body, and what alignment step is often missed?

Mount the arm onto the switch shaft so the .63 in nylon roller sits in the outside offset position; the step often missed is confirming the roller clears the cam track through the full 3 in travel before tightening the set screw.

What maintenance or replacement will the 9007C lever arm need over time?

The nylon roller and zinc arm should be inspected periodically; replace the arm if the .25 in roller width shows flat spots or the .31 in arm depth wears enough to change the actuation point.

What is the first limit that appears when the 9007C lever arm runs continuously?

The nylon roller will generate heat and wear faster than the zinc arm, so roller surface degradation is the first limit under sustained cycling.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.