SPEEDAIRE
SPEEDAIRE Double Acting Air Cylinder 1-1/2 In Bore 10 In Stroke
Double-acting air cylinder with a 1-1/2 inch bore and 10 inch stroke for linear motion control
- TypeDouble Acting
- Double-acting design powers both extend and retract strokes
- 10 in stroke length delivers long linear travel
- Stainless-steel body resists corrosion in harsh environments
- Chrome-plated piston rod reduces wear and extends seal life
- Front nose mounting simplifies installation in tight spaces
Double Acting Cylinder with 10 In Stroke
The SPEEDAIRE air cylinder uses a double acting design to provide force in both extension and retraction. It suits automation tasks that require controlled linear motion in two directions. A magnetic piston allows position sensing for precise control sequences. The unit is built for industrial pneumatic systems.
Stainless Steel Body with Nose Mounting
The round body is constructed from stainless steel with an anodized finish for corrosion resistance. A chrome plated piston rod reduces wear during cycling. Nose mounting at the front secures the cylinder directly to machinery frames. The non repairable design means the unit is replaced rather than rebuilt after service life.
1/8 Inch NPT Ports and Single Rod Layout
Two 1/8 inch NPT inlets supply compressed air to each side of the piston for double acting operation. The single rod configuration limits force symmetry between strokes. No cushions are fitted so end of stroke impact must be managed externally. The 10 inch stroke defines the maximum linear travel available.
Highlights
- Double-acting design powers both extend and retract strokes
- 10 in stroke length delivers long linear travel
- Stainless-steel body resists corrosion in harsh environments
- Chrome-plated piston rod reduces wear and extends seal life
- Front nose mounting simplifies installation in tight spaces
Specifications
| Brand | Speedaire |
|---|---|
| Type | Double Acting |
Questions about this item
What inlet size and thread type does the 1/8 in NPT port use?
The cylinder has a 1/8 in inlet with NPT threading for standard pneumatic fittings.
What mounting style and location are used on this cylinder?
It mounts by the nose at the front, so a compatible nose bracket or bulkhead nut is required.
How is the magnetic piston used during installation, and what is a common oversight?
The magnetic piston enables external position sensing; the step often missed is ordering and aligning the correct sensor bracket for the round body.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
