SPEEDAIRE
SPEEDAIRE 41H532 dovetail PNP switch 5-28V DC 200 mA
PNP dovetail switch operates at 5-28V DC with 200 mA max current for 3/4 to 4 inch bore cylinders
- PNP output simplifies PLC wiring
- 5-28 V DC range suits common control voltages
- 200 mA max current drives small loads directly
- LED indicator gives instant visual status
- 5 ft lead fits tight dovetail mounting
Industrial pneumatic sensor
The SPEEDAIRE 41H532 is a dovetail-style PNP proximity switch designed for pneumatic cylinders with bore diameters from 3/4 to 4 inches. It provides a normally open signal to a PLC or controller when the piston reaches the set position. The three-wire DC device suits automation engineers integrating position feedback into new or existing air systems.
Steady-state switching behaviour
Rated for a maximum switching current of 200 mA across a 5-28V DC supply range, the sensor maintains reliable output during continuous machine cycles. An integrated LED display confirms actuation status at a glance, simplifying troubleshooting on running lines without interrupting production.
Rugged mount and wiring
The dovetail housing clamps directly onto standard cylinder tie-rods, eliminating separate brackets and reducing installation time. A half-foot pigtail keeps cable routing tidy inside cable carriers while the -4 to 176 degrees F operating window handles cold starts and hot wash-down environments alike.
Highlights
- PNP output simplifies PLC wiring
- 5-28 V DC range suits common control voltages
- 200 mA max current drives small loads directly
- LED indicator gives instant visual status
- 5 ft lead fits tight dovetail mounting
Specifications
| Brand | SPEEDAIRE |
|---|
Questions about this item
How much heat or power does the 41H532 dovetail PNP switch draw when running continuously?
It operates on 5 to 28 V DC with a maximum switching current of 200 mA, so continuous power draw stays very low and produces negligible heat.
What voltage supply and wiring must I already have to install this switch?
You need a 5 to 28 V DC source and a three-wire connection; the switch includes a 0.5 ft lead for direct wiring.
Will the 41H532 work reliably on an older compressor bore that sits between 3/4 and 4 inches?
Yes, it is rated for bore diameters from 3/4 to 4 in and a temperature range of -4 to 176 °F, matching most legacy air systems.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
