SPEEDAIRE
SPEEDAIRE 31CC54 air roofing stapler, green, 160 staple capacity
Air-powered roofing stapler drives 16-gauge crowned staples from 1/2 to 1-1/2 inch with 160-staple capacity and adjustable depth control
- 160-staple magazine cuts reload time
- Bump-fire mode speeds repetitive fastening
- 12-inch height fits tight roof spaces
- Aluminium housing reduces operator fatigue
- 70–110 psi range matches common compressors
SPEEDAIRE 31CC54 Roofing Stapler
The SPEEDAIRE 31CC54 is an air-powered roofing stapler designed for professional contractors and tradespeople installing crowned staples. It accepts 16 gauge staples with a 1 inch crown width and leg lengths ranging from 1/2 inch to 1 1/2 inches. The aluminum housing provides durability for general duty applications on job sites. The magazine holds up to 160 staples for extended work periods.
Installation Requirements and Common Issues
Connect the tool to an air supply using a 1/4 inch NPT inlet with a minimum 3/8 inch hose size. Operating pressure must stay between 70 psi and 110 psi with a maximum of 110 psi. Air consumption is rated at 0.04 cfm. Common issues include staple jams from incorrect leg length or crown width, and inconsistent driving depth if air pressure falls below the minimum or the depth control is not adjusted for material thickness.
Practical Limits of Pneumatic Stapling
The bump firing mode allows rapid staple placement but requires careful trigger control to avoid unintended discharge. Top exhaust location directs air away from the operator but may blow debris upward in overhead work. The tool is restricted to crowned roofing staples within the specified gauge and dimension range; it cannot drive brad nails, narrow crown staples, or fasteners outside the 1/2 inch to 1 1/2 inch leg length. California Proposition 65 warnings apply for chemical exposure.
Highlights
- 160-staple magazine cuts reload time
- Bump-fire mode speeds repetitive fastening
- 12-inch height fits tight roof spaces
- Aluminium housing reduces operator fatigue
- 70–110 psi range matches common compressors
Specifications
| Brand | SPEEDAIRE |
|---|
Questions about this item
How can I verify the SPEEDAIRE 31CC54 is firing correctly after connecting the air supply?
Set the regulator between 70 and 110 psi, ensure the hose is at least 3/8 in, engage the bump-fire tip against the workpiece and confirm a staple drives flush each pull; the top exhaust should vent cleanly.
What comes with the stapler and what must I purchase separately?
The tool ships with the aluminum housing, depth-control dial and 1/4 in NPT inlet installed; you must supply staples (16 ga, 1 in crown, 1/2 to 1-1/2 in leg), a 3/8 in minimum air hose and a compressor delivering 0.04 cfm at 70–110 psi.
Which staple size should I choose for the 160-staple magazine?
Use 16-gauge crowned staples 1 in wide with leg lengths from 1/2 in up to 1-1/2 in; all fit the 160-capacity magazine and match the roofing fastener spec.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
