SPEEDAIRE
SPEEDAIRE 21AC05 Cut-Off Tool 1/4 in FNPT 4 in
A heavy-duty pneumatic cut-off tool with a 4 in wheel, 0.7 hp motor and 17,000 RPM for fast metal cutting
- 7 hp motor delivers strong cutting power
- 17,000 RPM max speed enables fast material removal
- 4 in wheel diameter handles a range of cut-off tasks
- Extended reach design improves access in tight spaces
- Free tool change system allows quick wheel swaps
Heavy-Duty 4 in Cut-Off Tool
The SPEEDAIRE 21AC05 is a heavy-duty pneumatic cut-off tool built for metal fabrication and maintenance tasks. It operates at a maximum speed of 17,000 RPM driven by a 0.7 hp motor. The tool accepts 4 in diameter wheels with a maximum thickness of 1/16 in and a round arbor hole. Its parallel wheel orientation suits straight cutting applications.
1/4 in NPT Air Inlet and Rear Exhaust
Connection to a compressed air supply requires a 1/4 in NPT female fitting at the inlet. The rear exhaust directs airflow away from the workpiece and operator. An extended reach design improves access in confined areas. A lever-type safety lock and speed control lever are integrated into the handle for operational control.
Free Tool Change for 4 in Wheels
The accessory-free tool change system allows wheel swaps without additional equipment, using the included 4 mm hex key and spanner. The 0.7 hp output and 17,000 RPM limit define the practical cutting capacity for heavy-duty use. California Proposition 65 warnings apply for chemicals known to cause cancer and reproductive harm.
Highlights
- 7 hp motor delivers strong cutting power
- 17,000 RPM max speed enables fast material removal
- 4 in wheel diameter handles a range of cut-off tasks
- Extended reach design improves access in tight spaces
- Free tool change system allows quick wheel swaps
Specifications
| Brand | SPEEDAIRE |
|---|
Questions about this item
What is the maximum wheel thickness this cut-off tool can accept?
The tool accepts cut-off wheels up to 1/16 in thick with a round arbor hole.
How much noise and vibration should I expect during extended use?
The 0.7 hp motor runs at 17,000 RPM with rear exhaust directing air away from the operator.
What air supply fitting do I need to connect this tool?
A 1/4 in NPT male quick-connect on the hose is required for the tool's 1/4 in FNPT air inlet.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
