Sound
Sound 2 in 1 accessory marine speakers white
Pair of 8-inch marine speakers deliver 320 W peak power with waterproof ABS housings
- 320 W peak power drives loud, clear marine audio
- 160 W RMS delivers sustained output without distortion
- Waterproof ABS housing withstands splashes on boats and off-road vehicles
- 8 oz magnet with aluminum voice coil produces rich, low-distortion sound
- 8 ft speaker wires included for flexible installation
Marine speaker pair for open-cockpit installs
This pair of 8-inch two-way marine speakers is built for boats, off-road rigs and other open-cockpit vehicles where a full-range stereo upgrade is wanted. The water-resistant ABS housings and low-profile grilles survive splash zones and tight mounting depths. Sold as a matched set with 9.8 ft speaker wires included for a straightforward install.
Sustained output holds at 160 watts RMS
The system delivers 160 watts RMS per pair, so continuous playback at party volumes stays clean without the compression that appears when peak-only ratings are pushed. Aluminium voice coils on 8 oz magnets keep distortion low across the 40 Hz to 18 kHz range even during long listening sessions. Four-ohm impedance matches common marine amplifiers without extra wiring complexity.
Shallow 0.94 in mounting depth eases heat
At just 0.94 inches behind the mounting surface the speakers leave ample air space, helping the ABS baskets shed heat during extended runs. The sealed construction prevents water ingress that could alter damping or cause corrosion-related noise. Total weight of 5.23 lbs keeps structural load minimal on thin fibreglass or aluminium panels.
Highlights
- 320 W peak power drives loud, clear marine audio
- 160 W RMS delivers sustained output without distortion
- Waterproof ABS housing withstands splashes on boats and off-road vehicles
- 8 oz magnet with aluminum voice coil produces rich, low-distortion sound
- 8 ft speaker wires included for flexible installation
Specifications
No published specifications for this item yet.
Questions about this item
How much heat and power draw should I expect from the 320 W peak, 160 W RMS, 4 ohm speakers during all-day use?
The speakers handle 160 W RMS at 4 ohms; sustained high-volume playback will produce noticeable warmth, so ensure the mounting area has free airflow around the 2.0 in depth.
What amplifier or head-unit specs do I need to drive these 4 ohm, 160 W RMS speakers?
You need an amplifier or marine head unit stable at 4 ohms and capable of delivering up to 160 W RMS per channel.
Will the 7.5 in cut-out and 0.94 in mounting depth fit the factory speaker openings in my older boat?
The cut-out diameter is 7.5 in and the mounting depth is 0.94 in; measure your existing openings against those dimensions before installing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



