Sony
Sony VPL-HS51 Projector Lamp LMPH130 135W 2000 Hrs
OEM replacement lamp module with a 135 W UHP bulb rated for 2,000 hours of use
- TypeUHP
- Wattage135W
- Lamp Life2,000 Hrs.
- Ready-to-install module with pre-assembled bulb and housing
- Genuine Ushio UHP 135W bulb for original brightness
- 2,000-hour rated lamp life for extended use
- ISO 9001 manufacturing quality checks on every unit
- Direct OEM replacement for Sony VPL-HS51 projectors
Replacement Lamp for Sony VPL-HS51
This projector lamp module is built for the Sony VPL-HS51 projector and ships as a complete bulb-and-housing assembly. It arrives ready for direct installation without extra tools or alignment steps. Home-theatre owners and small-venue operators can restore original brightness in minutes.
UHP 135W Bulb in Pre-Assembled Housing
The lamp uses a UHP-type bulb rated at 135 watts, mounted inside a finished housing that matches the factory mechanical interface. Because the module is fully assembled, the connector and mounting tabs line up exactly as the original did, eliminating the risk of mis-seating during a ceiling-mount swap. ISO 9001 production checks cover ignition, voltage and beam performance.
Rated 2,000 Hours of Lamp Life
The manufacturer specifies a 2,000-hour service life for this lamp under normal operating conditions. That figure determines the replacement interval for users who run the projector daily. Buyers who need longer intervals between changes should look for a higher-hour model.
Highlights
- Ready-to-install module with pre-assembled bulb and housing
- Genuine Ushio UHP 135W bulb for original brightness
- 2,000-hour rated lamp life for extended use
- ISO 9001 manufacturing quality checks on every unit
- Direct OEM replacement for Sony VPL-HS51 projectors
Specifications
| Brand | Sony |
|---|---|
| Type | UHP |
| Wattage | 135W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What wattage does the LMPH130 lamp draw and what is its rated life?
The lamp draws 135W and is rated for 2,000 hours of operation.
Which Sony projector models accept this lamp housing?
This module is built for the Sony VPL-HS51 projector and matches the LMPH130 form factor.
How is the lamp module installed and what step is often missed?
Power off and cool the projector, remove the lamp cover, slide the old module out, insert the new LMPH130 unit until it seats firmly, replace the cover, then reset the lamp timer in the menu so the projector tracks the new 2,000-hour life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



