We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Sony VPL-FE40 projector lamp module with housing

Sony

Sony VPL-FE40 Projector Lamp LMPF270 275W 2000 Hrs

SKU CH-KJHY-12QZ4

A ready-to-install 275 W replacement lamp module rated for 2,000 hours of use

  • TypeProjector Lamp
  • Wattage275W
  • Lamp Life2,000 Hrs.
  • Genuine OEM Ushio NSH bulb ensures reliable ignition
  • 275 W lamp delivers consistent brightness for presentations
  • 2 000 hour rated life reduces replacement frequency
  • Pre-assembled housing allows quick tool-free installation
  • ISO 9001 manufacturing quality checks verify performance

Ready-to-install replacement lamp

The Sony VPL-FE40 lamp module delivers a new 275W Ushio NSH bulb inside a complete housing. It matches the original LMPF270 specification and is built to ISO 9001 quality checks for beam performance, ignition, voltage and run-time. The unit arrives fully assembled so technicians can swap it without extra tools or alignment steps.

Rated 2,000 hours at 275 watts

The lamp is engineered for a 2,000-hour service life while drawing 275W during normal projection. OEM-grade manufacturing controls voltage stability and ignition consistency, which helps maintain steady brightness and colour balance across the rated interval. Thermal load and acoustic profile follow the projector’s original design envelope.

Direct fit for Sony VPL-FE40 projectors

This module slots into the VPL-FE40 chassis using the factory mounting points and connector, freeing the integrator from sourcing separate bulbs or housings. Compatibility is limited to the VPL-FE40 series; other Sony models or third-party projectors are not supported. Installation restores the projector to its original lamp-hour counter baseline.

Highlights

  • Genuine OEM Ushio NSH bulb ensures reliable ignition
  • 275 W lamp delivers consistent brightness for presentations
  • 2 000 hour rated life reduces replacement frequency
  • Pre-assembled housing allows quick tool-free installation
  • ISO 9001 manufacturing quality checks verify performance

Specifications

BrandSony
TypeProjector Lamp
Wattage275W
Lamp Life2,000 Hrs.

Questions about this item

How do I install the LMPF270 lamp module in my Sony VPL-FE40 projector, and which step do people often miss?

The module arrives fully assembled with the 275W Ushio NSH bulb inside its housing, so you only need to open the projector lamp door, remove the old unit, slide the new one in until it clicks, and then reset the lamp timer in the projector menu — the timer reset is the step most users forget.

What maintenance or replacement will the LMPF270 lamp need after it has been used for a while?

The lamp is rated for 2,000 hours of operation; once that limit is reached you simply replace the entire module with a new LMPF270 unit, as no separate bulb change or cleaning is required.

What is the first limit I will hit when running the LMPF270 continuously at full brightness?

The 2,000-hour rated lamp life is the primary limit; after those hours the 275W Ushio NSH bulb will reach end of life and the projector will indicate that a replacement is needed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.