We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Sony VPD-MX10 projector lamp module with 130W bulb in housing

Sony

Sony VPD-MX10 projector lamp 130W 1000 Hrs

SKU CH-ZRMD-R620M

A 130W replacement lamp module with housing, rated for 1000 hours of use in Sony projectors

  • TypeProjector Lamp
  • Wattage130W
  • Lamp Life1,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 130W UHP lamp delivers specified brightness for compatible Sony projectors
  • Rated 1000 hours of projection time before replacement
  • Manufactured under ISO9001 quality controls for consistent performance
  • Supplied new as a complete module for direct fit

What this lamp is

This Sony VPD-MX10 projector lamp module ships as a fully assembled 130W UHP bulb inside its housing, so it fits straight into the projector without extra assembly. It is intended for owners of compatible Sony projectors who need a direct replacement when the original lamp reaches end of life.

Thermals noise and power

The lamp draws 130W during operation and is rated for 1000 hours of typical use before brightness drops to half. Normal projector fan noise and heat output remain unchanged because the module matches the original electrical and thermal profile. No additional cooling or power provision is required beyond what the projector already supplies.

Installation and clearance

The unit arrives as a complete bulb-and-housing assembly, removing the need to handle a bare bulb or align separate components. It slots into the projector’s existing lamp compartment using the factory mounting points and connector. No tools, adapters or firmware updates are needed, and the original lamp door closes without modification.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 130W UHP lamp delivers specified brightness for compatible Sony projectors
  • Rated 1000 hours of projection time before replacement
  • Manufactured under ISO9001 quality controls for consistent performance
  • Supplied new as a complete module for direct fit

Specifications

BrandSony
TypeProjector Lamp
Wattage130W
Lamp Life1,000 Hrs.

Questions about this item

How do I install the VPD-MX10 lamp module and what step do people often miss?

The module arrives as a fully assembled bulb and housing; slide it into the projector's lamp compartment and secure the retaining screws, then reset the lamp-hour counter in the menu so the projector tracks the new 1000 Hrs life correctly.

What maintenance or replacement will this lamp need later?

After roughly 1000 Hrs of use the 130W UHP bulb reaches end of life; you simply purchase another VPD-MX10 module and swap it the same way, no separate filter or component service is required.

What limit appears first during long viewing sessions?

The 130W UHP bulb's rated 1000 Hrs lifespan is the primary limit; brightness will gradually decline as that hour count is approached.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.