Sony
Sony LMP-E220-A DLP replacement lamp
Replacement lamp and housing for Sony projectors including VPL-SW620, VPL-SW630CM, VPL-SW635C and VPL-SX630M models
- TypeProject Lamp
- Weight0.9900
- Compatible with Sony VPL-SW620 and VPL-SW630CM projectors
- Fits VPL-SW635C and VPL-SX630M models for easy replacement
- Ready-to-install lamp and housing module saves setup time
- New aftermarket unit with genuine AL series lamp inside
- Backed by a 90-day warranty for peace of mind
Sony LMP-E220-A projector lamp
The Sony LMP-E220-A is a new DLP replacement lamp module supplied with its housing. It is built for owners of compatible Sony projectors who need to restore original brightness after the existing lamp reaches end of life.
For Sony projector owners replacing a worn lamp
This module suits anyone maintaining a Sony projector that accepts the LMP-E220 code. Buyers whose projectors require a different part code or who need a bare bulb without the housing should look at other options.
Compatibility with listed Sony models
The lamp fits Sony projectors including VPL-SW620, VPL-SW630CM, VPL-SW635C and VPL-SX630M. Matching the LMP-E220 part number on your current unit is the single check that confirms this is the correct replacement.
Highlights
- Compatible with Sony VPL-SW620 and VPL-SW630CM projectors
- Fits VPL-SW635C and VPL-SX630M models for easy replacement
- Ready-to-install lamp and housing module saves setup time
- New aftermarket unit with genuine AL series lamp inside
- Backed by a 90-day warranty for peace of mind
Specifications
| Brand | Advanced Lamps |
|---|---|
| Model | LMP-E220-A |
| Part Number | LMP-E220-A |
| Type | Project Lamp |
| Weight | 0.9900 |
Questions about this item
Which Sony projector models accept the LMP-E220-A lamp and housing module?
This module fits the VPL-SW620, VPL-SW630CM, VPL-SW635C and VPL-SX630M projectors.
Can I keep using my existing ceiling mount and cables when I swap in this replacement lamp?
Yes, the lamp and housing slides into the same compartment, so your current mount, power cord and signal cables remain unchanged.
How do I confirm the new lamp is operating correctly after installation?
Power on the projector, open the lamp timer in the menu and verify it resets to zero hours with a steady, bright image.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
ONKRON G150 Full Motion Wall Mount 13-32" Gas Spring Black
- Carts & Stands
ONKRON G120 Full Motion TV Mount 13-32" Gas Spring Black
- Carts & Stands



