Soldering Wick Braid 2.0/3.5 mm 2 m
Desoldering braid in 2.0 mm and 3.5 mm widths, 2 m length, halogen-free with ultra-low residue for fast solder removal on PCBs
- Standards/CertificationsLead Free Compliant
- Lead-free compliant for safer electronics work
- 2 m roll gives plenty of length for multiple repairs
- Fine copper braid creates strong capillary action to pull excess solder
- Halogen-free, low-residue flux leaves boards clean with minimal cleanup
- Anti-scalding thumb-wheel dispenser protects fingers during desoldering
Desoldering Braid 2.0/3.5 mm
This halogen-free, ultra-low-residue copper wick is designed for electronic component repair and PCB rework. The fine braid promotes strong capillary action to pull excess solder from joints quickly. It suits professionals and hobbyists working on mobile phone motherboards, tablets, keyboards and general circuit boards. The 2 m roll provides ample length for multiple desoldering tasks.
Upgrades from basic wick or pump tools
The anti-scalding thumb-wheel dispenser with a stainless steel spout gives controlled feed and heat protection during use. This design improves precision on small, hard-to-reach pads where a simple coil or manual pump is awkward. The jump is worth it when you need low-residue, halogen-free cleanup on dense boards without spreading flux or risking component damage from excessive heat.
Capacity and headroom
The 2.0 mm and 3.5 mm widths handle typical through-hole and surface-mount joints on consumer electronics. The 2 m length covers dozens of component removals such as relays, switches or connectors. It runs out on very large ground planes or high-mass connectors where solder volume exceeds the braid's capillary capacity in a single pass.
Highlights
- Lead-free compliant for safer electronics work
- 2 m roll gives plenty of length for multiple repairs
- Fine copper braid creates strong capillary action to pull excess solder
- Halogen-free, low-residue flux leaves boards clean with minimal cleanup
- Anti-scalding thumb-wheel dispenser protects fingers during desoldering
Specifications
| Standards/Certifications | Lead Free Compliant |
|---|
Questions about this item
What width options does the 2 m soldering wick come in?
The braid is supplied in 2.0 mm and 3.5 mm widths on a single 2 m roll.
How do I use the anti-scalding thumb wheel dispenser without overheating the board?
Press the thumb wheel to advance fresh braid, apply the iron briefly — just long enough for solder to wick — then release the wheel and lift both away together.
When should I replace the wick during a desoldering job?
Replace the section once it turns silver with absorbed solder; saturated braid loses capillary action and can leave residue on the pad.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
