Soldering 900M-T 10 Tips 1.2D-4C
Ten electroplated copper tips in shapes I, B, K, 1.2D, 1.6D, 2.4D, 3.2D, 2C, 3C and 4C fit 900M-T stations and operate from 200 to 480 degrees
- Watts2 watts
- Compatibility/FitmentOut-Opening, Narrow Stile, Store Front Doors
- Fast heat-up with oxygen-free copper core
- Electroplated iron-nickel resists oxidation for 25000 welds
- Ten tip shapes cover fine to broad joints
- Fits 936, 937, 938, 969, 8586, 852D stations
- 42 mm length, 6 mm outer diameter for secure fit
900M-T 10-tip soldering set
This set supplies ten interchangeable soldering tips built on oxygen-free copper with an electroplated iron and nickel finish. The tips suit lower-temperature soldering tasks and fit 900M-T series stations. Hobbyists, repair technicians and light-assembly workers can select the profile that matches each joint without changing tools.
Thermals and power draw
Each tip operates across a 200 to 480 °C range and the copper base conducts heat rapidly to the working surface. The electroplated coating resists oxidation so tips stay effective for up to 25000 welding spots under normal use. The station itself draws only 2 watts, keeping energy consumption and heat output low during extended sessions.
Tip geometry decides fit
The set includes shapes I, B, K, 1.2D, 1.6D, 2.4D, 3.2D, 2C, 3C and 4C, each 42 mm long with a 6 mm outer diameter and 4 mm inner diameter. Buyers needing a profile not listed here or a different diameter will have to source a separate kit.
Highlights
- Fast heat-up with oxygen-free copper core
- Electroplated iron-nickel resists oxidation for 25000 welds
- Ten tip shapes cover fine to broad joints
- Fits 936, 937, 938, 969, 8586, 852D stations
- 42 mm length, 6 mm outer diameter for secure fit
Specifications
| Watts | 2 watts |
|---|---|
| Compatibility/Fitment | Out-Opening, Narrow Stile, Store Front Doors |
Questions about this item
How do I fit the 900M-T tips onto my 936 station, and what step causes a loose fit?
Slide each tip into the 6 mm outer-diameter barrel until it seats against the inner 4 mm bore, then tighten the retaining sleeve; skipping the sleeve leaves the tip free to wobble.
When will the electroplated iron coating need replacement, and what signals the end of life?
The coating is rated for at least 25000 welding spots; once the tip develops a stubborn black oxide layer that cleaning cannot remove, the plating is exhausted and the tip should be swapped.
What temperature ceiling will the tips hit first during long sessions at 480 °C?
The 200–480 °C range is the design limit; sustained operation at the top end accelerates oxidation and shortens the usable life of the electroplated surface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
