Soldering 12 2.5mm 9.8ft 3pcs
Copper desoldering braid with no-clean flux, 2.5 mm wide by 9.8 ft long, three pieces per pack
- Compatibility/FitmentOut-Opening, Narrow Stile, Store Front Doors
- Standards/CertificationsLead Free Compliant
- 100 % copper braid conducts heat fast for quick solder removal
- No-clean flux leaves minimal non-conductive residue after desoldering
- Fine braid design creates strong capillary action to pull excess solder
- 5 mm width suits small PCB components and tight joints
- Three 9.8 ft rolls provide ample length for multiple rework tasks
Copper desoldering braid for PCB repair
This 2.5 mm wide copper braid uses flat stitch weaving to create strong capillary action that pulls excess solder from small PCB boards. The 100 % copper construction conducts heat quickly so the wick draws solder away without damaging pads or components. Three pieces at 9.8 ft each supply enough length for repeated rework sessions in labs, workshops or home benches.
Simple placement with flux core
Lay the braid over the joint, apply the iron tip and the no-clean flux activates instantly to start wicking solder into the copper strands. Residue left behind is non-conductive and non-corrosive so boards do not require extra cleaning steps. The narrow 0.10 in width fits tight component spacing but cannot reach underneath large connectors or dense BGA packages where access is blocked.
Steady performance during long desoldering runs
Copper mass absorbs heat continuously so the braid remains effective across multiple joints without saturating as quickly as thinner wicks. Flux activity stays consistent through the full 9.8 ft roll, preventing dry spots that can stall solder uptake. For very high-volume production lines the single 2.5 mm size may require frequent roll changes compared to bulk dispenser formats.
Highlights
- 100 % copper braid conducts heat fast for quick solder removal
- No-clean flux leaves minimal non-conductive residue after desoldering
- Fine braid design creates strong capillary action to pull excess solder
- 5 mm width suits small PCB components and tight joints
- Three 9.8 ft rolls provide ample length for multiple rework tasks
Specifications
| Compatibility/Fitment | Out-Opening, Narrow Stile, Store Front Doors |
|---|---|
| Standards/Certifications | Lead Free Compliant |
Questions about this item
How can I confirm the solder wick is removing solder effectively after I apply it to a joint?
The copper braid will draw molten solder into its strands through capillary action, leaving the pad clean with only a small amount of non-conductive, non-corrosive residue that requires no further cleaning.
What items are included in the package and is any additional flux required for use?
The pack contains three spools of 2.5 mm wide, 9.8 ft long lead-free desoldering braid with no-clean flux already embedded in the copper; no separate flux purchase is needed.
Which width and length combination should I select for general PCB rework tasks?
The 2.5 mm width and 9.8 ft length per spool suit a broad range of component sizes and provide enough material for multiple desoldering jobs across the three included pieces.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
