Solder Wick Braid 20Ft Desoldering Kit with Brush
Two 10-foot rolls of braided copper desoldering wick and a dual-ended anti-static brush remove molten solder and dust from circuit boards
- Compatibility/FitmentXX2601
- Two 10-foot rolls supply 20 ft of braid for extended rework sessions
- Pure copper braid structure absorbs molten solder quickly from the tip
- 08-inch width fits tight pads and dense component layouts
- Dual-ended anti-static brush clears dust and flux residue from boards
- Kit covers PCB repair, DIY electronics and component removal in one set
Solder Wick Kit 20 Ft
This kit provides two 10 ft rolls of pure copper desoldering braid and a dual-ended anti-static brush. It is intended for technicians and hobbyists removing solder from printed circuit boards during repair or prototype work.
Copper Braid Absorption Limits
The braided copper structure draws molten solder through capillary action once both wick and joint reach melting temperature. Each roll measures 0.08 in wide, so wider pads or large ground planes may require multiple passes or a broader wick not included here.
XX2601 Compatibility Reference
The supplier lists fitment code XX2601 as the compatibility identifier for this set. Buyers who need a different width, flux formulation or length should verify that code before ordering.
Highlights
- Two 10-foot rolls supply 20 ft of braid for extended rework sessions
- Pure copper braid structure absorbs molten solder quickly from the tip
- 08-inch width fits tight pads and dense component layouts
- Dual-ended anti-static brush clears dust and flux residue from boards
- Kit covers PCB repair, DIY electronics and component removal in one set
Specifications
| Compatibility/Fitment | XX2601 |
|---|
Questions about this item
Should I get the single 10 ft roll or the 20 ft kit with two rolls?
The kit supplies two rolls of 10 ft each, giving 20 ft total; buy the kit if you expect frequent desoldering work.
How much solder can the 0.08 in wide braid actually remove?
The fine copper braid draws molten solder away from joints when heated, leaving pads clean for rework.
Does the XX2601 fitment code mean it works with standard soldering irons?
XX2601 is the manufacturer’s compatibility reference; the wick works with any iron that can melt solder.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
