SMUGDESK
SMUGDESK SAS 4 SATA 7Pin Male to 4 SATA 7Pin Male 50cm 6Gbps Cable
Connects four SATA drives to a RAID controller at 6Gbps with 50cm shielded cable and gold-plated pins for 24-hour server operation
- Connect up to four drives with one 50 cm cable
- 6 Gbps bandwidth keeps RAID arrays running at full speed
- Shielded conductors cut crosstalk for stable 24-hour operation
- Gold-plated pins resist oxidation for reliable long-term contact
- Compact 50 cm length simplifies cable routing in tight chassis
Multidrive SATA RAID cable
This 50cm internal cable connects four SATA 7Pin male host ports to four SATA 7Pin male target ports, enabling multiharddisk connections inside servers, NAS units and storage arrays. It supports up to 6Gbps bandwidth and works with SATA III hard drives, solidstate drives and RAID controller cards. Shielded conductors reduce crosstalk and electromagnetic interference during heavy readwrite workloads. Goldplated pins resist oxidation for steady 24hour operation.
IT technicians and system integrators
The cable suits professionals building rack servers, configuring RAID sets or upgrading multidrive chassis where tidy 50cm routing is required. It is not for buyers who need external drive connectivity or longer runs between separate enclosures. Enthusiasts without internal SATA host ports should look at other solutions.
Four-port 7Pin male-to-male layout
The single specification that decides fit is the four-port 7Pin male host to four-port 7Pin male target arrangement, which matches controllers and backplanes expecting this exact connector pattern. Verify your hardware uses the same pin layout before purchase.
Highlights
- Connect up to four drives with one 50 cm cable
- 6 Gbps bandwidth keeps RAID arrays running at full speed
- Shielded conductors cut crosstalk for stable 24-hour operation
- Gold-plated pins resist oxidation for reliable long-term contact
- Compact 50 cm length simplifies cable routing in tight chassis
Specifications
No published specifications for this item yet.
Questions about this item
How do I install the 50cm SAS 4 SATA 7Pin Male cable in a server chassis?
Connect the four host-end SATA 7Pin male plugs to the RAID controller or motherboard ports, then attach the four target-end SATA 7Pin male plugs to the drives, routing the 50cm length to avoid sharp bends; the common mistake is reversing host and target ends.
What maintenance or replacement will the gold-plated SATA connectors need later?
The gold-plated pins resist oxidation for 24/7 operation, so no routine cleaning is required; replace the cable only if physical damage or intermittent drive detection appears after prolonged use.
What limit appears first when the cable runs sustained multi-drive RAID workloads?
The 6Gbps per-lane bandwidth ceiling is the first bottleneck under heavy simultaneous read-write traffic across all four SATA channels.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115342BTC
In stock
