We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
SMUGDESK handheld cable tester with main and remote units, LED indicators, RJ45 RJ11 RJ12 ports

SMUGDESK

SMUGDESK RJ45 RJ11 RJ12 Network Cable Tester Continuity OpenCircuit ShortCircuit MisWiring Fault Checking

SKU CH-NTH9-EFHBT

Tests RJ45, RJ11 and RJ12 cables for continuity, open circuit, short circuit and miswiring faults using a main unit and remote module with sequential LED indicators

  • Tests RJ45, RJ11 and RJ12 cables for network and telecom lines
  • Finds open, short, crosswire and mispin faults on Cat5 and Cat6 UTP
  • Main unit plus remote module checks long cables across rooms and walls
  • Sequential LEDs show pin-to-pin status for fast fault diagnosis
  • Compact handheld build suits installers, technicians and home DIY projects

Multipurpose RJ45 RJ11 RJ12 Cable Tester

This handheld tester checks continuity and wiring faults on Cat5 and Cat6 UTP Ethernet cables plus RJ11 and RJ12 telephone cords. A main unit and a separate remote module let you verify long runs across rooms or wall sockets without bringing both ends together. Sequential LEDs show each pin connection for fast fault diagnosis. Compact design suits installers, technicians and home DIY troubleshooting.

Practical Limits of Continuity Testing

The tool identifies open circuits, short circuits, crossed wires and mis-pinned connections on unshielded twisted-pair cables up to Cat6 performance. It does not measure bandwidth, crosstalk, attenuation or certify links to any Category standard. Power over Ethernet voltage and active network equipment must be absent during testing. Battery is not supplied so you must provide a suitable cell before use.

Check Your Setup Before Ordering

Ensure the cables you need to test terminate in RJ45, RJ11 or RJ12 plugs that fit the tester ports. Verify you can access both ends of each run or place the remote module at the far socket for in-wall or patch-panel links. Confirm you have a compatible battery available as none is included. The tester cannot diagnose faults on fibre, coaxial or shielded cables with non-standard pinouts.

Highlights

  • Tests RJ45, RJ11 and RJ12 cables for network and telecom lines
  • Finds open, short, crosswire and mispin faults on Cat5 and Cat6 UTP
  • Main unit plus remote module checks long cables across rooms and walls
  • Sequential LEDs show pin-to-pin status for fast fault diagnosis
  • Compact handheld build suits installers, technicians and home DIY projects

Specifications

No published specifications for this item yet.

Questions about this item

Should I pick the 45, 11 or 12 connector for my cable?

The tester handles RJ45 Ethernet plus RJ11 and RJ12 telephone plugs, so match the port to the connector on the cable you are checking.

What do the sequential LEDs tell me once the cable is plugged in?

They light in order to show each pin-to-pin connection, revealing opens, shorts, crossed pairs or miswired pins across the full run.

How does the separate remote unit change what I can test on site?

It lets you verify long or wall-embedded runs by placing the remote at the far-end socket instead of bringing both ends together.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.