We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Mini SAS 26-pin SFF8088 male to four SATA female breakout cable with latches, 1 metre

SMUGDESK

SMUGDESK Mini SAS 26Pin SFF8088 Male to 4×SATA Female Breakout Cable with Latch 1M/3.3FT

SKU CH-PW17-FZ4PY

Converts one 26-pin SFF8088 male port into four SATA female ports with locking latches for secure server storage connections

  • Single SFF-8088 port fans out to four SATA drives
  • Locking latches prevent accidental disconnection during operation
  • 3 ft length fits standard server rack wiring
  • Supports four simultaneous SATA devices for storage arrays
  • Rugged build reduces signal loss and interference

Single SFF8088 to four SATA breakout

This Mini SAS cable converts one 26pin SFF8088 male connector into four SATA 4pin female ports for attaching up to four drives. It links a SAS host or RAID controller to a SATA backplane in servers and storage arrays. The 1M/3.3FT length fits standard rack wiring runs. Builders needing more than four drives per port will need additional cables.

Latched connectors for secure fit

Locking latches on each connector prevent accidental disconnection during vibration or maintenance. Rugged construction minimises signal loss, crosstalk and electromagnetic interference for reliable data transfer. No active cooling or power draw is involved. The passive design adds no audible noise to the chassis.

Shielded wiring suits rack installs

The shielded assembly resists EMI in dense server environments. Straight breakout geometry simplifies routing between controller and backplane. Latch release requires deliberate finger pressure, reducing risk of accidental unplugging. Installers working in extremely tight bends should verify the bend radius suits their layout.

Highlights

  • Single SFF-8088 port fans out to four SATA drives
  • Locking latches prevent accidental disconnection during operation
  • 3 ft length fits standard server rack wiring
  • Supports four simultaneous SATA devices for storage arrays
  • Rugged build reduces signal loss and interference

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the SFF8088 end to my SAS controller without the latch catching?

Align the 26 pin SFF8088 male connector with the controller port, press straight in until the latch clicks, then route the four SATA 4pin female ends to the backplane bays.

Which part of this cable is most likely to need replacement after repeated drive swaps?

The four SATA 4pin female connectors see the most insertions and can loosen over time; the SFF8088 male end and the 1M/3.3FT cable body typically remain intact.

What limits sustained throughput when four drives are active on this breakout?

The single SFF8088 male link carries all four SATA streams, so its lane bandwidth becomes the bottleneck before individual SATA device limits are reached.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.