SMUGDESK
SMUGDESK 67MM 240W USB5.0 80Gbps 90° Up Angled Extension Cable
A 67 mm USB 5.0 male-to-male extension cable delivers 80 Gbps data, 240 W power and 8K 60 Hz video through a 90° up-angled flat FPC design
- 80Gbps ultra-high-speed data with USB5.0 Gen4
- 240W maximum power delivery for fast charging
- 90° up-angled connector fits tight spaces
- 67mm ultra-slim FPC flat cable for easy routing
- Supports 16K, 8K@60Hz and 5K video output
Compact 67 mm USB5.0 Extension
This 67 mm male-to-male USB-C cable extends a connection by a very short distance using USB5.0 Gen4 technology. It carries 80 Gbps data, 240 W power delivery and video signals up to 16K, 8K at 60 Hz and 5K resolution. The ultra-thin FPC ribbon and 90° up-angled plugs fit tight spaces in embedded devices, industrial panels and high-end displays.
Suits tight-panel installs; not for long runs
Builders routing cables inside shallow enclosures, behind wall-mounted screens or between stacked boards gain a low-profile right-angle exit that lies flat. The 67 mm length only bridges adjacent ports, so anyone needing desk-length reach, cable-chain routing or standard straight connectors should choose a different cable.
Verify port orientation and power needs
Confirm both host and peripheral have USB-C receptacles that accept a male plug with an upward 90° bend; a downward or side-entry port may block the connector. Ensure the power source and sink negotiate 240 W if full charging speed is required, and that the video source can output the desired 16K, 8K 60 Hz or 5K mode over the link.
Highlights
- 80Gbps ultra-high-speed data with USB5.0 Gen4
- 240W maximum power delivery for fast charging
- 90° up-angled connector fits tight spaces
- 67mm ultra-slim FPC flat cable for easy routing
- Supports 16K, 8K@60Hz and 5K video output
Specifications
No published specifications for this item yet.
Questions about this item
Does this cable need any active electronics or drivers in the host device to reach 80 Gbps?
No, it is a passive FPC flat cable built to the USB5.0 Gen4 specification, so the host and peripheral must each support 80 Gbps natively for the link to run at that speed.
Will the 90° up‑angled connector fit alongside a straight USB‑C cable plugged into the adjacent port on my laptop?
The low‑profile up‑angled design points the cable away from the chassis, leaving the neighbouring port clear for a standard straight connector in most tight‑spacing layouts.
How can I verify the link is actually running at 80 Gbps and delivering 240 W after I connect it?
Check the operating‑system USB controller view or a hardware USB analyser — both should report a Gen4 80 Gbps connection and a 240 W power contract when the attached devices negotiate those rates.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



