SMUGDESK 4 Pack 11 Inch USB C Male to 4 Pin Bare Open End Pigtail Cables

DIY USB-C pigtail cable set

This set provides four 11-inch USB-C male to 4-pin bare open-ended pigtail cables intended for electronics hobbyists, maintenance technicians and DIY circuit modification enthusiasts. Each cable arrives with pre-stripped conductors to eliminate manual insulation removal and speed up soldering or wiring tasks. The standard Type-C plug connects to four exposed core wires for direct termination on terminal blocks, PCBs or power modules. It suits custom power assemblies, equipment modification and electronic repair replacement projects.

5V 2A power and basic data capacity

The cables support steady 5V 2A DC power output alongside basic signal data transmission for small Type-C powered devices, experimental modules, embedded boards and custom charging docks. This headroom covers typical low-power repair and prototyping needs such as damaged port replacement or homemade desktop power bank wiring. Demands exceeding 2A or requiring high-speed data protocols fall outside the rated capability and are not supported by this cable design.

Flexible PVC jacket for repeated bending

A soft, bend-resistant PVC outer jacket protects the internal conductors during repeated folding, twisting and thermal stress from soldering work. The durable wire core resists breakage and short-circuit risks under normal bench handling and installation. No active cooling or special thermal management is required given the low 5V 2A operating envelope. Power draw remains minimal and noise is non-existent as the assembly contains no active components.