We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black DC 7.9x5.5mm male plugs with bare wire ends, 16AWG

SMUGDESK

SMUGDESK 2 Pack 12V DC 7.9x5.5mm Male to Bare Wire Power Cord 16AWG

SKU CH-4VJ2-JDFMF

A two-pack of 12 V DC 7.9 × 5.5 mm male-to-bare-wire pigtails built with 16 AWG copper for stable, low-resistance power connections in repairs and DIY projects

  • Two cables included for spare or parallel installations
  • 16AWG copper wire reduces resistance for stable 12V delivery
  • 9 × 5.5 mm DC male plug matches common DC7909 ports
  • Bare wire ends allow direct soldering or terminal connections
  • Flexible insulation resists abrasion during routing and repair work

Two-Pack 12V DC 7.9x5.5mm Power Pigtails

This set includes two DC7909 male-to-bare-wire cables built for 12V low-voltage power connections. They suit repair technicians, DIY hobbyists and anyone needing spare leads for adapters, surveillance gear or LED equipment that use the 7.9mm x 5.5mm barrel interface.

Replacing Damaged or Short Factory Leads

Swap these in when an original power cord is frayed, the plug is loose or the cable length falls short of a new mounting position. The jump is worth it if the device draws within the 16AWG copper rating and you need a clean bare-end termination for soldering, screw terminals or custom wiring harnesses.

Simple Solder or Terminal Installation

Strip the flexible insulation, tin the 16AWG copper strands and attach to your target connector — no crimp tools required for basic joints. What usually goes wrong is reversing polarity at the bare ends, so verify positive and negative with a multimeter before energising the circuit.

Highlights

  • Two cables included for spare or parallel installations
  • 16AWG copper wire reduces resistance for stable 12V delivery
  • 9 × 5.5 mm DC male plug matches common DC7909 ports
  • Bare wire ends allow direct soldering or terminal connections
  • Flexible insulation resists abrasion during routing and repair work

Specifications

No published specifications for this item yet.

Questions about this item

Will the 7.9 x 5.5 mm DC male plug fit my device's DC7909 input?

Yes, the 7.9 mm outer and 5.5 mm inner pin dimensions match the standard DC7909 interface used by many 12 V notebook adapters, surveillance gear and LED equipment.

How do I connect the bare wire ends, and what mistake should I avoid?

Strip only the minimum insulation needed, then solder or crimp to your terminal block; the common error is reversing polarity, so identify positive and negative with a multimeter before making permanent joints.

When will I need to replace these 16 AWG pigtails?

Replace them if the insulation cracks, the copper strands corrode or the plug becomes loose, as damaged 16 AWG cable can increase resistance and cause voltage drop on 12 V circuits.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.