We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two short USB-A female to bare-wire power cables, 11-inch length, pre-stripped ends

SMUGDESK

SMUGDESK 2 Pack 11 Inch USB A Female to 2 Pin Bare Wire Power Cable

SKU CH-0NSS-TWXTF

Two 11-inch USB-A female to bare-wire pigtails deliver 5 V 3 A power for DIY repairs and custom builds

  • Two cables included for spare or parallel projects
  • 11 inch length keeps internal wiring tidy
  • Power-only design delivers up to 5V 3A reliably
  • Pre-stripped bare wires speed up soldering and repairs
  • Flexible jacket with tinned copper resists bending wear

DIY power cable for USB equipment repair

This two-pack supplies 11-inch USB-A female to bare-wire pigtails built for power-only connections. Each cable carries 5V at up to 3A using tinned copper conductors inside a flexible jacket. Pre-stripped ends let you solder directly to boards or modules without extra prep. The design targets technicians and hobbyists replacing damaged ports or powering custom circuits.

Thermals noise and power draw

Power-only wiring means no data signalling, so the cable runs cool during typical 5V loads. The tinned copper cores keep resistance low, limiting voltage drop across the short 11-inch run. No active cooling or fans are involved, so operation is silent. Current capacity stops at 3A, matching the rated output for small USB-powered devices.

Pre-stripped bare wires speed up soldering

Exposed conductors eliminate the need for stripping tools and reduce installation time inside tight enclosures. The flexible jacket resists bending fatigue when routed through equipment housings. Two cables in the pack provide a spare for testing or a second repair job. Data lines are absent, so the cables cannot be used for communication or firmware updates.

Highlights

  • Two cables included for spare or parallel projects
  • 11 inch length keeps internal wiring tidy
  • Power-only design delivers up to 5V 3A reliably
  • Pre-stripped bare wires speed up soldering and repairs
  • Flexible jacket with tinned copper resists bending wear

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 11 inch USB A female to 2 pin bare wire cable inside my device?

Solder the pre-stripped tinned copper wires directly to the power pads on your circuit board or power module, then secure the short cable with adhesive or cable ties to prevent strain on the joints.

What maintenance will the 2 pack of 11 inch power-only pigtail cables need over time?

Inspect the solder joints and flexible jacket periodically for cracks or loosening caused by vibration or heat cycles; replace a cable if the insulation is damaged or resistance rises.

What is the first limit I will hit when running these 11 inch cables at continuous load?

The 5V 3A rating is the hard ceiling; sustained draws near that level will cause voltage drop and heating in the thin conductors before any other factor becomes an issue.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.