SMUGDESK
SMUGDESK 2×30cm USB 2.0 A Male to 2 Pin Bare Wire Power Cable
Two 30 cm USB 2.0 A male to bare-wire pigtails supply 5 V power at up to 3 A for DIY wiring, repairs and custom 5 V projects
- Two cables included for multiple DIY wiring tasks
- USB 2.0 A male to bare wires delivers 5V power up to 3A
- Pre-stripped open ends enable quick soldering to boards and modules
- Flexible durable insulation resists cracking under repeated bending
- Compact 30cm pigtail suits embedded devices and custom power projects
USB 2.0 A Male Power Pigtail
This pack supplies two 30 cm USB 2.0 Type-A male to bare-wire pigtails built solely for 5 V power delivery at up to 3 A. They suit hobbyists, technicians and anyone repairing or prototyping low-voltage USB-powered gear.
Pre-Stripped Open Ends for Quick Wiring
Each cable terminates in two pre-stripped bare conductors, removing the need to strip insulation before soldering or crimping. The flexible jacket resists cracking under repeated bending, making daily bench work and permanent installs equally practical.
5 V 3 A Rating Defines Compatibility
The cables carry only power lines, so they cannot transmit data. They suit any 5 V load drawing 3 A or less, such as LED strips, embedded boards or replacement power leads, but will not work for devices needing data lines or higher voltage.
Highlights
- Two cables included for multiple DIY wiring tasks
- USB 2.0 A male to bare wires delivers 5V power up to 3A
- Pre-stripped open ends enable quick soldering to boards and modules
- Flexible durable insulation resists cracking under repeated bending
- Compact 30cm pigtail suits embedded devices and custom power projects
Specifications
No published specifications for this item yet.
Questions about this item
What does the USB 2.0 A male interface cap in practice?
The USB 2.0 A male connector delivers 5 V power only, rated up to 3 A, with no data lines present.
What physical clearance does the 30 cm pigtail need?
The 30 cm (11.8 in) cable with pre-stripped bare wire ends fits tight enclosures and requires only enough room for the USB A plug and solder joints.
How is the bare-wire end installed, and what step is often missed?
Solder or crimp the two pre-stripped wires to your board or terminal block, then verify polarity before applying power.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



