SMARTBOARD
SMARTBOARD SLR40WI OEM Osram Projector Lamp 230W 2500 Hrs
A new 230W projector lamp module with Osram P-VIP bulb and housing, rated for 2500 hours
- TypeProjector Lamp
- Wattage230W
- Lamp Life2,500 Hrs.
- Ready-to-install module saves setup time
- Osram P-VIP 230W bulb delivers reliable brightness
- 2,500-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards for consistent performance
- Direct-fit for SmartBoard SLR40WI projectors
Direct Replacement Lamp
The SMARTBOARD SLR40WI OEM lamp module includes a new Osram P-VIP 230W bulb pre-mounted in its housing. It matches the original SmartBoard part 20-01501-20 and is manufactured to ISO9001 quality standards. Installation is straightforward because the assembly arrives fully assembled.
For Projector Maintenance
This unit suits anyone whose SmartBoard projector requires the SLR40WI module and who wants a genuine OEM light source with a rated 2,500-hour life. Buyers needing a different wattage, connector layout or a bare bulb without housing should look at other listings.
230W Osram P-VIP Bulb
The lamp uses a 230W Osram P-VIP bulb rated for 2,500 hours of operation. This wattage and lamp type determine brightness, heat output and compatibility with the projector's power supply. Verify that your projector specifies a 230W P-VIP module before ordering.
Highlights
- Ready-to-install module saves setup time
- Osram P-VIP 230W bulb delivers reliable brightness
- 2,500-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards for consistent performance
- Direct-fit for SmartBoard SLR40WI projectors
Specifications
| Brand | SmartBoard |
|---|---|
| Type | Projector Lamp |
| Wattage | 230W |
| Lamp Life | 2,500 Hrs. |
Questions about this item
What projector model does the SLR40WI lamp module fit?
The SLR40WI lamp module is a direct replacement for SmartBoard projectors using part number 20-01501-20. It ships as a complete housing with the 230 W Osram P-VIP bulb already installed.
How do I install the SLR40WI lamp and what step is often missed?
Power off the projector and let it cool completely. Remove the lamp cover, release the retaining screws, slide out the old module, insert the new SLR40WI unit until it seats firmly, tighten the screws, replace the cover, then reset the lamp-hour counter in the projector menu.
When should I replace the Osram P-VIP 230 W bulb inside this module?
The lamp is rated for 2 500 hours of typical use. Plan a replacement when the projector’s lamp-hour counter approaches that figure or when image brightness noticeably drops.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



