We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
SmallRig double ball head 1135 with cold shoe and 1/4" screw, 180° articulation

SmallRig

SmallRig Double Ball Head 1135 Cold Shoe 1/4" Screw 180°

SKU CH-GXPH-TS80M

A compact double ball head with a cold shoe and 1/4"-20 screws on both ends, providing 180° articulation for positioning monitors or lights on a DSLR

  • TypeAccessory
  • Cold shoe mount adds accessories directly to camera
  • 1/4"-20 screw on both ends secures monitors and lights
  • 180° articulation positions gear at any angle
  • Single locking knob locks both balls instantly
  • Compact aluminium build withstands daily location use

Double Ball Head 1135

The SmallRig Double Ball Head 1135 combines a cold shoe mount with a 1/4"-20 thumb screw on each end. It gives photographers and videographers a compact, adjustable link between a DSLR or camcorder shoe and accessories such as monitors or LED lights. The single locking knob secures both ball joints simultaneously for fast, stable positioning.

Replaces fixed shoe adapters

A fixed cold shoe bracket only holds gear at one angle. This head adds 180-degree articulation on each joint, so you can tilt a monitor for overhead framing or aim a light without remounting. The upgrade is worth it whenever you need to reposition accessories quickly during a shoot. It is not for rigs that demand more than two pivot points or heavier loads than the thumb screws can clamp.

Cold shoe and 1/4" interface limits

The cold shoe foot slides into a standard camera shoe but provides no electrical contacts for flash or audio. Both 1/4"-20 threads rely on thumb screws, so torque is limited to hand tightening. The 20 mm ball diameter caps the leverage you can apply before the joint slips, making it unsuitable for large monitors or heavy cages.

Highlights

  • Cold shoe mount adds accessories directly to camera
  • 1/4"-20 screw on both ends secures monitors and lights
  • 180° articulation positions gear at any angle
  • Single locking knob locks both balls instantly
  • Compact aluminium build withstands daily location use

Specifications

BrandSMALLRIG
TypeAccessory

Questions about this item

Does the 1/4"-20 screw fit my monitor's mounting point?

Yes, the 1/4"-20 screw on top matches the standard thread used by most monitors and accessories.

How do I lock the 180° articulation in place?

Tighten the single locking knob firmly after positioning; the common mistake is leaving it loose, which lets the joint shift under load.

Will the cold shoe adapter wear out from repeated mounting?

The metal shoe mount is built for frequent use; if the friction spring weakens over time, the whole unit is replaced rather than serviced.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.