We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass nails with round heads, 280 pieces in a pile

Small Tiny Nails 1.2x20mm Brass 280pcs

SKU CH-991Z-SR0MG

A pack of 280 brass nails measuring 1.2x20mm with 2.5mm round heads for woodworking and decorative projects

  • 280 pieces supplied so projects stay stocked
  • Brass construction resists corrosion for lasting hold
  • 2×20 mm shank fits fine detail work
  • Horizontal threads on the shank resist loosening
  • Round 2.5 mm heads spread force evenly

280 Brass Nails 1.2 × 20 mm

This pack contains 280 tiny brass nails measuring 1.2 mm in diameter and 20 mm in length. The round heads are 2.5 mm wide, and the shanks carry horizontal threads that resist loosening after driving. Brass construction gives good corrosion resistance and lasting hardness for indoor woodwork and craft projects.

For fine woodwork and decorative assembly

The nails suit model-making, jewellery boxes, picture frames, cabinet backs and other small wooden items where a standard brad would split the grain or look oversized. They are not intended for structural framing, outdoor exposure, or any joint that requires a larger shank diameter or greater holding power than the 1.2 mm wire provides.

1.2 mm shank diameter decides fit

The 1.2 mm wire size determines whether the nail can enter pilot holes in thin stock without splitting it and whether the threads can engage the surrounding wood fibres. If the project demands a thicker fastener for heavier joinery, a different nail diameter must be chosen.

Highlights

  • 280 pieces supplied so projects stay stocked
  • Brass construction resists corrosion for lasting hold
  • 2×20 mm shank fits fine detail work
  • Horizontal threads on the shank resist loosening
  • Round 2.5 mm heads spread force evenly

Specifications

No published specifications for this item yet.

Questions about this item

What diameter pilot hole suits the 1.2 mm shank?

Drill a 1 mm pilot hole in hardwoods; in soft woods the 1.2 mm shank can often be driven without one.

How do I avoid bending the 20 mm nails when hammering?

Hold the nail with needle-nose pliers, tap lightly to start, then drive straight in — sideways force bends the thin shank.

Will the brass nails corrode in outdoor projects?

Brass resists rust, but prolonged moisture can cause surface tarnish; apply a clear sealant if the piece stays outside.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.