Slugger By Fein
Slugger By Fein 63134524042 Annular Cutter 2-1/16 in 2 in depth
High-speed steel annular cutter bores 2-1/16 in holes to 2 in depth with Weldon flat shank
- High-speed steel construction resists wear during metal cutting
- Bright finish reduces friction for smoother drilling action
- Weldon flat shank ensures secure fit in magnetic drill chucks
- 3/4 inch shank diameter matches common industrial tool holders
- 2 inch cutting depth handles thick plate in a single pass
Slugger By Fein 2-1/16 in Annular Cutter
The Slugger By Fein annular cutter is built for metal fabrication professionals who need clean, accurate holes in structural steel and plate. Its high-speed steel construction and Weldon flat shank suit magnetic-base drills and stationary presses in shop or field work. The 2-inch cutting depth handles thick material in a single pass.
Weldon Flat Shank and Bright Finish
The 3/4 in Weldon flat shank locks positively into compatible arbors, preventing spin-out during heavy feed rates. A bright, uncoated surface resists galling on mild steel and allows easy visual inspection of cutting edges. The straight-flute geometry ejects chips efficiently without clogging in deep cuts.
High-Speed Steel Cutting Performance
High-speed steel retains hardness at the temperatures generated by 2-inch deep cuts in carbon steel, reducing the frequency of resharpening. Steady feed pressure and proper coolant keep noise and vibration low while extending tool life. The cutter draws only the power the drill motor supplies, with no additional electrical demand.
Highlights
- High-speed steel construction resists wear during metal cutting
- Bright finish reduces friction for smoother drilling action
- Weldon flat shank ensures secure fit in magnetic drill chucks
- 3/4 inch shank diameter matches common industrial tool holders
- 2 inch cutting depth handles thick plate in a single pass
Specifications
| Brand | SLUGGER BY FEIN |
|---|
Questions about this item
Does the 3/4 in Weldon Flat shank fit standard mag-drill arbors?
The 3/4 in Weldon Flat shank matches the common mag-drill arbor size, so it seats directly without an adapter.
What is the maximum material thickness this cutter can handle?
The maximum cutting depth is 2 in, so it can drill through plates up to that thickness in a single pass.
How do you secure the cutter so it will not spin in the arbor?
Align the Weldon flat with the arbor set screws, tighten both screws evenly, then verify the cutter cannot rotate by hand before starting the machine.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
