Slugger By Fein
Slugger By Fein 63134508042 Annular Cutter
High-speed steel annular cutter with a Weldon flat shank for magnetic-base drilling machines
- High-speed steel construction for extended tool life
- 2-inch cutting diameter handles large holes efficiently
- 2-inch maximum cutting depth suits thick materials
- 3/4-inch Weldon shank fits standard magnetic drills
- Bright finish reduces friction during cutting operations
2-inch Annular Cutter for Magnetic Drills
The Slugger by Fein 63134508042 is a high-speed steel annular cutter built for magnetic-base drilling machines. Its 2-inch diameter and 2-inch maximum cutting depth suit fabricators who need to produce large-diameter through-holes in structural steel, plate or pipe. The bright finish and Weldon flat shank make it a direct fit for standard 3/4-inch drive arbors without adapters.
Consistent Chip Evacuation in Deep Cuts
High-speed steel construction maintains edge hardness while the flute geometry clears chips steadily during the full 2-inch depth of cut. This reduces the risk of binding or overheating that can stall shorter-cycle cutters when the hole deepens. Steady feed pressure yields a clean, round hole without the walk common in twist-drill alternatives.
Weldon Flat Shank for Quick Tool Changes
The 3/4-inch Weldon flat locks securely into magnetic drill arbors with a single set-screw turn, so operators can swap cutters in seconds between hole sizes. Bright surface treatment resists surface corrosion during storage and does not add coating thickness that could affect fit in tight stack-ups. The cutter is ready for immediate use in the shop or field.
Highlights
- High-speed steel construction for extended tool life
- 2-inch cutting diameter handles large holes efficiently
- 2-inch maximum cutting depth suits thick materials
- 3/4-inch Weldon shank fits standard magnetic drills
- Bright finish reduces friction during cutting operations
Specifications
| Brand | SLUGGER BY FEIN |
|---|
Questions about this item
How much heat does the 63134508042 generate during extended cutting sessions?
The high-speed steel construction and bright finish dissipate heat effectively during continuous operation, and the Weldon flat shank ensures secure torque transfer without excessive friction buildup.
What machine or arbor is required to run the 63134508042?
A magnetic drill or compatible machine with a 3/4 in Weldon flat shank receiver is needed to mount and drive this annular cutter.
Will the 63134508042 fit my older magnetic drill that takes a 3/4 in Weldon shank?
Yes, the 3/4 in Weldon flat shank matches the standard interface on many legacy magnetic drills, so it installs directly without adapters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
