Slugger By Fein
Slugger By Fein 63134333041 Annular Cutter 16 pneumatic accessory
High-speed steel annular cutter with a 3/4 inch Weldon flat shank for one inch cutting depth
- High-speed steel construction resists wear during heavy cutting
- Bright finish reduces friction for smoother material penetration
- Weldon flat shank ensures secure fit in magnetic drill chucks
- 3/4 inch shank diameter matches standard industrial tool holders
- 1 inch maximum cutting depth handles thick plate in a single pass
What the annular cutter does
The Slugger By Fein 63134333041 annular cutter removes a 16 mm ring of material to produce a 1 5/16 in hole with a maximum cutting depth of 1 in. It fits magnetic drills or drill presses that accept a 3/4 in Weldon flat shank and is intended for metal fabrication and maintenance tasks where a solid twist drill would be too large or slow.
Capacity and where it stops
The high speed steel body with a bright finish handles mild and structural steel up to the rated 1 in depth in a single pass; thicker plates require multiple passes or a longer cutter not supplied here. The 16 mm cutting diameter fixes the hole size, so the tool cannot be used for smaller or larger bores without changing the cutter.
Heat, noise and air consumption
Cutting fluid or paste is recommended to control temperature at the cutting edges during extended cuts; without it the bright finish can overheat and dull quickly. Noise level depends on the host machine and workpiece clamping rather than the cutter itself. Air consumption is determined by the pneumatic drive unit, not by this accessory.
Highlights
- High-speed steel construction resists wear during heavy cutting
- Bright finish reduces friction for smoother material penetration
- Weldon flat shank ensures secure fit in magnetic drill chucks
- 3/4 inch shank diameter matches standard industrial tool holders
- 1 inch maximum cutting depth handles thick plate in a single pass
Specifications
| Brand | SLUGGER BY FEIN |
|---|
Questions about this item
Will the 3/4 in Weldon Flat shank fit the magnetic drill base I already own?
The cutter uses a 3/4 in Weldon Flat shank, the standard interface for most magnetic drill bases and annular cutter arbors.
How do I confirm the 1 in cutting depth is being reached during operation?
Watch the chips and feed pressure — when the cutter breaks through at 1 in the motor load drops and a clean slug ejects from the centre.
Does the box include pilot pins or coolant for the 1-5/16 in diameter cutter?
Only the high-speed steel annular cutter is supplied; pilot pins and cutting fluid must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
