We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent nitrile shaft seal, 1/4 inch wide, HM14 design

SKF

SKF 16095 Shaft Seal HM14 Nitrile 1/4" Width

SKU CH-4E9H-7JFW1

Rotary shaft seal with nitrile lip, 1/4" width, rated for 10 psi and 2,752 RPM

  • ColorTransparent
  • Width1/4"
  • SKF 16095 shaft seal fits 2.328 in shaft for precise sealing
  • HM14 nitrile lip resists oil, grease, fuel and hot water
  • Single-lip contact design handles 10 psi pressure reliably
  • Rated to 2,752 RPM for high-speed rotary applications
  • 1/4 in width installs easily in standard agricultural machinery housings

Shaft Seal for Agricultural Machinery

The SKF 16095 rotary shaft seal uses an HM14 design with a single nitrile rubber lip suited for grease-lubricated equipment. It measures 2.328 inches inside diameter by 2.375 inches outside diameter with a .25 inch overall width and handles fluids such as mineral oils, gasoline, diesel and hot water.

Fits Grease-Lubricated Rotating Shafts

Mechanics maintaining farm implements or industrial gearboxes running up to 2 752 RPM will find the dimensions and pressure rating appropriate. Builders working on high-pressure hydraulic systems above 10 psi or assemblies requiring a spring-loaded or multi-lip seal should select a different design.

Critical Spec Is 10 psi Maximum Pressure

This single-lip HM14 seal is rated for only 10 psi, so it cannot serve in pressurised hydraulic circuits or high-speed pump housings. Verify the application stays within that limit before ordering.

Highlights

  • SKF 16095 shaft seal fits 2.328 in shaft for precise sealing
  • HM14 nitrile lip resists oil, grease, fuel and hot water
  • Single-lip contact design handles 10 psi pressure reliably
  • Rated to 2,752 RPM for high-speed rotary applications
  • 1/4 in width installs easily in standard agricultural machinery housings

Specifications

BrandSKF
ColorTransparent
Width1/4"

Questions about this item

When will the nitrile lip on this 16095 shaft seal need replacement?

The nitrile lip wears gradually; inspect it during routine maintenance and replace the seal if leakage appears or the lip shows hardening or cracking.

What rotational speed limit applies before the HM14 seal overheats?

The seal is rated for a maximum of 2 752 RPM; sustained operation above this speed increases lip temperature and accelerates wear.

How much heat and power loss does the 10 psi pressure rating create during all-day operation?

At the rated 10 psi the seal generates minimal frictional heat; the single nitrile lip and uncoated case keep power loss low for continuous grease-lubricated service.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.