SIEMENS
SIEMENS 6EP13321LB00 DC Power Supply 24V 60W 2.5A DIN Rail
DIN-rail 24V DC power supply delivering 60W at 2.5A with 120/230V AC input and green LED status indicator
- 24 V DC output powers control circuits reliably
- 60 W capacity handles typical automation loads
- 5 A continuous current with 27 A peak for inrush
- DIN rail mounting fits standard 32 mm panel slots
- Green LED status indicator shows operating condition at a glance
SITOP PSU100L 60 W DIN Rail Supply
The SIEMENS 6EP13321LB00 is a single-phase switching power supply built for control cabinets and automation panels. It accepts 120 or 230 V AC input and delivers a regulated 24 V DC output at 2.5 A, making it suited for PLCs, sensors and small actuator groups. The compact plastic housing clips onto standard DIN rail and carries an IP20 rating for indoor use.
Capacity and headroom
Continuous output is 60 W with a 2.5 A nominal current, while a short-term peak of 27 A handles inrush from contactors or capacitive loads. Hold-up time exceeds 20 ms to bridge brief mains interruptions. Output ripple stays within 150 mV peak-to-peak and 10 mV RMS, keeping sensitive analog loops stable. The unit operates from 0 to 60 °C without derating.
Bundled status indicator
A green LED on the front face signals output OK, giving immediate visual confirmation without extra wiring or monitoring modules. No software, cables or configuration tools are included; the supply is ready to mount and wire. The NEMA 1 plastic case and 125 mm by 32 mm by 120 mm footprint leave room for adjacent modules on crowded rails.
Highlights
- 24 V DC output powers control circuits reliably
- 60 W capacity handles typical automation loads
- 5 A continuous current with 27 A peak for inrush
- DIN rail mounting fits standard 32 mm panel slots
- Green LED status indicator shows operating condition at a glance
Specifications
| Brand | SIEMENS |
|---|
Questions about this item
Will this 24 V DC 2.5 A supply run reliably on the same 120/230 V AC panel that feeds my older SITOP modules?
Yes, the input range is 120/230 V AC at 50 to 60 Hz single-phase, so it shares the same mains feed as legacy SITOP units.
How do I confirm the 60 W output is healthy after wiring it to the DIN rail?
The green LED OK signal lights when the 24 V DC output is within specification.
Does the box include the DIN rail clip or must I order it separately?
The unit has an integrated DIN rail mount; no separate clip is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
