Sharp
Sharp XG-C330X OEM Replacement Projector Lamp 275W 2000 Hrs
A 275 W metal-halide XG-C330X projector lamp rated for 2,000 hours, supplied as a complete housing for quick installation
- TypeProjector Lamp
- Wattage275W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 275 W metal halide bulb delivers rated brightness
- 2000-hour lamp life extends replacement interval
- OEM-spec assembly meets ISO 9001 quality checks
- Compatible with Sharp XG-C330X projectors
Replacement lamp for Sharp projectors
This new Sharp XG-C330X module includes a Ushio metal-halide bulb rated at 275 W and 2 000 hours of life. It arrives fully assembled inside its housing, so you can install it without handling the bare lamp. The unit matches the original ANC430LP specification for compatible Sharp models.
Who should buy this and who should not
Buyers needing a direct OEM-spec replacement for a failed or dimming Sharp projector lamp will find the correct fit and brightness here. Users whose projector requires a different wattage, connector or form factor must choose the module specified for that model.
Deciding specification
The 275 W metal-halide rating and 2 000-hour rated life determine whether this lamp matches the projector's original design. Verify those figures against the projector's service manual before ordering.
Highlights
- Ready-to-install module saves setup time
- 275 W metal halide bulb delivers rated brightness
- 2000-hour lamp life extends replacement interval
- OEM-spec assembly meets ISO 9001 quality checks
- Compatible with Sharp XG-C330X projectors
Specifications
| Brand | Sharp |
|---|---|
| Type | Projector Lamp |
| Wattage | 275W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the ANC430LP housing fit the Sharp XG-C330X projector without modification?
Yes, the fully assembled module matches the original ANC430LP form factor and slides into the Sharp XG-C330X lamp compartment without any modification.
Which step do installers most often skip when fitting the 275 W Ushio bulb module?
Many forget to reset the projector's lamp-hour counter after insertion, so the unit continues to warn that the old 2,000-hour limit has been reached.
When should the metal-halide lamp be replaced if the projector runs typical daily hours?
Plan on a new module after roughly 2,000 hours of operation; the ISO 9001-qualified Ushio bulb is rated for that lifespan before brightness drops below usable levels.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



