Sharp
Sharp XG-C330 Projector Lamp 275W 2000 Hrs
A complete 275 W lamp module rated for 2,000 hours, supplied with housing for direct installation in Sharp projectors
- TypeProjector Lamp
- Wattage275W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- Consistent brightness from 275W Ushio metal halide lamp
- Up to 2000 hours of projection before replacement
- Built to ISO 9001 quality standards for reliable performance
- Direct OEM replacement matching Sharp ANC430LP specifications
Ready-to-install replacement lamp
The Sharp XG-C330 module arrives as a complete housing with a 275 W Ushio metal-halide bulb already fitted, so it drops straight into compatible Sharp projectors without extra assembly. It is aimed at owners who need a direct swap for the original ANC430LP unit and want the projector back in service quickly. Buyers looking for a bare bulb without housing or a different wattage will not find that here.
Rated output and service life
The lamp draws 275 W and is rated for 2 000 hours of typical operation, giving a clear expectation for replacement planning. Manufacturing follows ISO 9001 checks covering beam performance, ignition voltage, connections and run-time to keep output stable during normal use.
Consistent output over the full cycle
Quality testing verifies that ignition, voltage and beam characteristics remain within spec from first start to the end of the rated 2 000-hour span, so brightness does not fade prematurely during extended sessions. Each unit is inspected against the same standard before it ships.
Highlights
- Ready to install with pre-assembled bulb and housing
- Consistent brightness from 275W Ushio metal halide lamp
- Up to 2000 hours of projection before replacement
- Built to ISO 9001 quality standards for reliable performance
- Direct OEM replacement matching Sharp ANC430LP specifications
Specifications
| Brand | Sharp |
|---|---|
| Type | Projector Lamp |
| Wattage | 275W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the pre-assembled Sharp XG-C330 lamp module without damaging the 275W Ushio bulb?
Power down and unplug the projector, let it cool completely, open the lamp door, remove the old module by its handle, insert the new housing until it clicks, then close the door before powering on.
Which component will require replacement after roughly 2,000 hours of operation?
The 275W Ushio metal halide bulb inside the housing reaches its rated 2,000-hour lifespan, so the entire lamp module must be swapped at that point.
What thermal limit triggers automatic shutdown during extended sessions?
The projector’s internal temperature sensor will cut power if the 275W lamp exceeds safe operating heat, protecting both the Ushio bulb and the optical engine.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
ID TECH IDMB-333133B credit card reader
- MagStripe Reader
- Keyboard Wedge
Brother TZES121 9mm Black on Clear Extra Strength Adhesive Tape pos accessory
- Label Accessories
- Black on Clear Indu…
Intermec E23067 DuraTran II Gloss Polyester Thermal Transfer Labels pos accessory
- Thermal Transfer Pr…
- Desktop



