Sharp
Sharp PG-F211X Projector Lamp 200W
A 200 W replacement lamp module with housing delivers 2,000 to 3,000 hours of life for Sharp projectors
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Genuine Phoenix SHP 200W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- Lamp life reaches 2,000 hours normal or 3,000 hours economy mode
- Manufactured under ISO 9001 quality standards for consistent performance
- Compatible with Sharp PG-F211X projectors using ANXR30LP/1 module
Direct Replacement Module
This Sharp PG-F211X lamp module delivers a 200W Phoenix SHP bulb inside a complete housing that matches the ANXR30LP/1 specification. It arrives fully assembled so the projector can be relamped without separate bulb handling.
For Standard Brightness Needs
The rated 2,000-hour normal life and 3,000-hour economy life suit classrooms and meeting rooms that run typical presentation cycles. Buyers who need longer intervals between replacements or higher lumen output should consider projectors designed for extended-life light sources.
Tool-Free Swap In Minutes
The all-in-one housing slides into the lamp compartment and locks with the projector's existing latch, requiring no screws or alignment of bare bulbs. The most common issue is forgetting to reset the lamp-hour counter in the menu, which leaves the replacement warning active.
Highlights
- Genuine Phoenix SHP 200W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- Lamp life reaches 2,000 hours normal or 3,000 hours economy mode
- Manufactured under ISO 9001 quality standards for consistent performance
- Compatible with Sharp PG-F211X projectors using ANXR30LP/1 module
Specifications
| Brand | Sharp |
|---|---|
| Type | Projector Lamp |
| Wattage | 200W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Which Sharp projectors accept the PG-F211X lamp module with the 200W Phoenix SHP bulb?
The lamp is built for the Sharp PG-F211X projector; it matches the ANXR30LP/1 part number and fits the original housing without modification.
Will the 200W Phoenix SHP lamp run correctly if my projector previously used a different OEM bulb?
Yes — the module meets the same 200W specification and ignition requirements, so it operates normally alongside the projector's existing ballast and cooling system.
How can I verify the new lamp is performing correctly after installation?
Reset the lamp-hour counter, then confirm the projector reports 0 hours and runs without flicker; expect up to 2000 hours in normal mode or 3000 hours in economy mode.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
MADE IN USA TONER toner cartridge for KIP 7170 103 2 x 400 gm black
- Black
- Compatible



