Sharp
Sharp DT-5000 Projector Lamp 275W 5000 Hrs
275W replacement lamp module with 5,000-hour life for Sharp projectors
- TypeProjector Lamp
- Wattage275W
- Lamp Life5,000 Hrs.
- Ready to install with pre-assembled housing and bulb
- 275W Phoenix SHP bulb delivers specified brightness
- 5,000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible replacement for Sharp ANK2LP/1 projectors
Ready-to-install lamp module
The Sharp DT-5000 projector lamp arrives as a fully assembled 275W bulb and housing unit. It is designed for direct replacement in compatible Sharp projectors without additional assembly. The module uses a Phoenix SHP bulb and meets ISO 9001 manufacturing standards for beam performance and run-time.
Restores original brightness
This lamp replaces a dimmed or failed original module and returns the projector to its factory light output. The rated life is 5,000 hours, so the upgrade is worthwhile when the existing lamp nears that limit or shows noticeable brightness loss. Each unit undergoes ignition, voltage and connection checks before shipping.
Fits Sharp DT-5000 projectors
The housing matches the OEM form factor for the DT-5000 series, allowing tool-free insertion into the projector's lamp compartment. No extra cables, filters or adapters are required. The 275W power draw matches the projector's original specification, leaving the existing power supply and cooling system unchanged.
Highlights
- Ready to install with pre-assembled housing and bulb
- 275W Phoenix SHP bulb delivers specified brightness
- 5,000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible replacement for Sharp ANK2LP/1 projectors
Specifications
| Brand | Sharp |
|---|---|
| Type | Projector Lamp |
| Wattage | 275W |
| Lamp Life | 5,000 Hrs. |
Questions about this item
Will the 275 W lamp module fit straight into my Sharp DT-5000 projector without extra brackets?
The module ships as a complete bulb-and-housing assembly matched to the DT-5000, so it slides into the existing lamp cage with no additional brackets required.
What is the installation step users most often miss when swapping the lamp?
After inserting the new module, the lamp-hour counter in the projector menu must be reset to zero; otherwise the projector will continue to warn of end-of-life based on the old count.
How often should I expect to replace the 275 W Phoenix bulb inside this housing?
The lamp is rated for 5,000 hours of typical use; plan on a new module once the projector’s hour meter approaches that figure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Honeywell CW45-QBC-0 4-Bay Battery Charger pos system
- No Screen
- 0.7400



