We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Sharp ANK15LP projector lamp module with 250W bulb in housing

Sharp

Sharp ANK15LP 250W projector lamp

SKU CH-JX02-K723T

A 250 W projector lamp module with a 3,000-hour rated life for Sharp projectors

  • TypeProjector Lamp
  • Wattage250W
  • Lamp Life3,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 250 W Phoenix SHP bulb delivers rated brightness
  • 3,000-hour lamp life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Compatible with Sharp projectors using ANK15LP module

Ready-to-install lamp module

The Sharp ANK15LP is a complete replacement lamp module supplied with a new Phoenix SHP 250W bulb already fitted inside its housing. It is intended for owners of compatible Sharp projectors who need a direct swap without handling a bare lamp. The unit arrives assembled so installation only requires opening the projector door and slotting the module into place. No alignment or extra tools are needed.

Steady output for 3,000 hours

Rated at 250 watts, the lamp is specified for 3,000 hours of operation before brightness drops to half its initial level. That figure reflects continuous use under normal projector cooling rather than a short-burst maximum. Consistent airflow and regular filter cleaning help the lamp reach the rated lifespan without premature dimming or colour shift.

Fixed 250W power envelope

The module draws a constant 250W from the projector’s dedicated lamp driver, so the host must supply exactly that voltage and current profile. Projectors designed for a different wattage or ignition sequence will not strike the lamp or may stress the ballast. Buyers whose projectors call for a higher or lower wattage lamp cannot use this module.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 250 W Phoenix SHP bulb delivers rated brightness
  • 3,000-hour lamp life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Compatible with Sharp projectors using ANK15LP module

Specifications

BrandSharp
TypeProjector Lamp
Wattage250W
Lamp Life3,000 Hrs.

Questions about this item

How much heat and power does the 250W Sharp ANK15LP lamp produce during extended daily use?

The lamp draws 250W of electrical power, and nearly all of that energy becomes heat inside the projector; the unit’s cooling system must dissipate that load continuously during operation.

Which Sharp projector models accept the ANK15LP lamp module so I know it will fit my existing unit?

The ANK15LP is designed as a direct replacement for Sharp projectors that originally shipped with this lamp code; verify your projector’s manual lists ANK15LP as the correct part number before ordering.

Will the 3,000-hour rated life of this lamp be affected if I alternate it with an older lamp in the same projector?

Each lamp’s 3,000-hour rating is independent; swapping lamps does not change the rated life of either module, though the projector’s hour counter should be reset when the new ANK15LP is installed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.