We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Sharp ANC55LP/1 projector lamp module with metal halide bulb in housing

Sharp

Sharp ANC55LP/1 Projector Lamp 150W 2000 Hrs

SKU CH-3YGR-6N7NF

Contains a 150 W metal-halide bulb in a pre-assembled housing rated for 2,000 hours of use

  • TypeProjector Lamp
  • Wattage150W
  • Lamp Life2,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 150W metal halide lamp delivers 2000 hours of projection time
  • Manufactured to ISO9001 quality standards for reliable performance
  • Genuine OEM components from Philips Osram Ushio Phoenix Iwasaki Matsushita
  • Each unit tested for beam ignition voltage and runtime

Ready-to-install lamp module

The Sharp ANC55LP/1 replacement projector lamp arrives as a fully assembled bulb and housing unit, so it fits directly into compatible Sharp projectors without extra assembly steps. Installation typically takes minutes by opening the lamp door, removing the old module and sliding the new one into place until it seats firmly. Common issues arise when the lamp door is not fully closed or the connector is misaligned, both of which prevent the projector from powering on.

150W metal halide light source

The lamp uses a 150W Phoenix metal halide bulb rated for 2000 hours of typical operation. Brightness will gradually decline as the lamp ages, and colour balance may shift noticeably after the rated life is exceeded. Running the projector in high-brightness modes or without adequate ventilation can shorten the practical lifespan below the 2000 hour figure.

Compatibility limited to specific Sharp models

This module is designed only for Sharp projectors that accept the ANC55LP/1 part number; it will not fit other brands or Sharp models that use a different lamp code. Buyers who need a lamp for a different projector must verify the exact part number before ordering, as cross-model substitution is not supported. The lamp is manufactured to ISO 9001 quality standards using OEM-grade components from recognised bulb makers.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 150W metal halide lamp delivers 2000 hours of projection time
  • Manufactured to ISO9001 quality standards for reliable performance
  • Genuine OEM components from Philips Osram Ushio Phoenix Iwasaki Matsushita
  • Each unit tested for beam ignition voltage and runtime

Specifications

BrandSharp
TypeProjector Lamp
Wattage150W
Lamp Life2,000 Hrs.

Questions about this item

How can I verify the lamp is operating correctly after installation?

The projector should display a bright, uniform image immediately; the lamp timer will start counting from zero toward the 2,000-hour rated life.

What components are included and what must I purchase separately?

The module arrives as a fully assembled 150 W metal-halide bulb inside its housing, ready to install; no extra parts are required.

Which version of the ANC55LP/1 should I choose among the options offered?

Three OEM variants come from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita, plus a compatible version built with genuine OEM parts; all meet ISO 9001 quality checks.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.