We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
SharkBite brass push-to-connect coupling, straight adapter, 1/2 inch both ends

SharkBite

SharkBite UIP4008 1/2" Brass Transition Coupling

SKU CH-N7T7-X313C

Push-to-connect brass coupling joins 1/2 inch CTS and PVC pipe for potable water up to 200 psi and 200 °F

  • Push-to-connect design speeds installation without tools
  • Brass construction resists corrosion for long service life
  • Handles 200 psi and 200 °F for demanding potable-water systems
  • CTS-to-PVC transition joins dissimilar pipe materials in one fitting
  • Compact 1 1/4 in length fits tight spaces

SharkBite UIP4008 Brass Coupling

This SharkBite UIP4008 fitting joins 1/2 inch copper tube to PVC pipe using push-to-connect ends. It suits plumbers and homeowners making potable water repairs or alterations without soldering or glue. The straight adapter design fits tight spaces where a transition is required. It is not for gas lines or drainage systems needing solvent weld joints.

Capacity and Headroom

The coupling handles a maximum operating pressure of 200 psi and a maximum operating temperature of 200 Degrees F. These ratings cover typical residential hot and cold water supply lines. It runs out of headroom in high-pressure commercial mains or steam applications exceeding those limits. The 1 1/4 in overall length limits use where a longer transition piece is needed.

Thermals Noise and Power Draw

As a passive brass fitting it draws no power and produces no noise during normal operation. The brass body conducts heat from hot water lines but remains within safe handling temperatures at the rated 200 Degrees F. No thermal cycling fatigue is expected within the specified pressure and temperature range. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.

Highlights

  • Push-to-connect design speeds installation without tools
  • Brass construction resists corrosion for long service life
  • Handles 200 psi and 200 °F for demanding potable-water systems
  • CTS-to-PVC transition joins dissimilar pipe materials in one fitting
  • Compact 1 1/4 in length fits tight spaces

Specifications

BrandSHARKBITE

Questions about this item

Will the 1/2" push-to-connect ends seal reliably on my existing copper and CPVC lines without soldering or glue?

Yes, each end is a push-to-connect design made for 1/2" outer-diameter tube, so it grips copper or CPVC instantly without solder, flux, or solvent cement.

How can I verify the joint is holding at the rated 200 psi after I push the pipes in?

Pressurise the system and inspect the coupling; a proper seal shows no water seepage at either port while the gauge reads up to 200 psi.

Does the brass coupling come with any sealant, tape, or pipe inserts, or must I purchase them separately?

The fitting arrives pre-lubricated for push-in assembly and includes no thread sealant, tape, or stiffener inserts; buy those separately if your local code requires them.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.