We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-to-connect reducing tee with three ports

SharkBite

SharkBite U416LF Reducing Tee 1 in x 3/4 in x 1 in 200 psi

SKU CH-P4Z7-M2W8W MPN U416LF

A DZR brass reducing tee joins 1 in and 3/4 in tubing with push-to-connect ends for potable water at 200 psi

  • TypeDrain Components
  • Push-to-connect design speeds up installation without soldering
  • DZR brass construction resists dezincification in potable water systems
  • Reducing tee connects 1 in, 3/4 in and 1 in tubes in one fitting
  • Rated for 200 psi maximum operating pressure
  • Lead-free brass meets potable water safety requirements

Reducing Tee for Potable Water

The SharkBite U416LF is a DZR brass reducing tee designed for potable water systems. It connects three push-to-connect ports in a 1 in, 3/4 in, 1 in configuration. The fitting suits residential and light commercial plumbing installations. It arrives new and ready for immediate use.

Capacity and Pressure Headroom

The fitting handles a maximum operating pressure of 200 psi, providing ample headroom for typical municipal supply pressures. It comfortably manages standard household demand across the 1 in and 3/4 in branches. Flow restriction increases if multiple high-demand fixtures run simultaneously on the reduced port. The DZR brass body resists dezincification for long service life.

Push-to-Connect Interface Limits

All three ports use a push-to-connect mechanism that seals on the tube outer diameter without solder, clamps or glue. The joint relies on correct tube insertion depth and a clean, round tube end for a watertight seal. The design is not compatible with threaded pipe ends unless a suitable adapter is used. System pressure must not exceed the 200 psi rating.

Highlights

  • Push-to-connect design speeds up installation without soldering
  • DZR brass construction resists dezincification in potable water systems
  • Reducing tee connects 1 in, 3/4 in and 1 in tubes in one fitting
  • Rated for 200 psi maximum operating pressure
  • Lead-free brass meets potable water safety requirements

Specifications

TypeDrain Components
BrandSharkbite
ModelU416LF

Questions about this item

Will the 1 in push-to-connect ends join my existing copper pipe without soldering?

Yes, both 1 in ports use push-to-connect so they grip copper, PEX or CPVC directly with no flame or solder needed.

How can I confirm the DZR brass tee is sealed at 200 psi after installation?

Pressurise the system to its working pressure and inspect each of the three push-to-connect joints; no visible water escape means the seals are holding.

Does the box include any pipe inserts or disconnect clips for the 3/4 in branch?

The fitting ships with pre-applied thread sealant only; pipe inserts and disconnect clips are sold separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.