We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-fit coupling, 3/8 by 1/2 inch tube size

SharkBite

SharkBite U009LF Push-Fit Coupling Fitting 3/8 in x 1/2 in Brass

SKU CH-YEHJ-797C8

Push-fit brass coupling joins 3/8 in and 1/2 in tubes for potable water up to 200 psi and 200 °F

  • Push-to-connect design joins copper or PEX without tools
  • Brass body resists corrosion in potable water systems
  • Rated for 200 psi and 200 °F maximum operating conditions
  • Compact 4 1/2 in length fits tight plumbing spaces
  • California Proposition 65 warning applies to this fitting

3/8 in to 1/2 in Push-Fit Coupling

This brass push-fit coupling joins 3/8 in and 1/2 in tubing without solder or tools. It is intended for potable water systems in residential and light commercial plumbing. The fitting installs by pushing each tube end into the respective port until seated.

200 psi and 200 °F operating limits

Rated for 200 psi maximum operating pressure and 200 °F maximum temperature, the coupling handles typical hot and cold water distribution. It is not suited for steam lines, high-pressure hydronics or applications exceeding either limit.

Brass body with no pre-applied sealant

The solid brass construction resists corrosion in normal water chemistry and runs silently under flow. No thread sealant is included or required for the push-to-connect ports, so joints remain clean and serviceable.

Highlights

  • Push-to-connect design joins copper or PEX without tools
  • Brass body resists corrosion in potable water systems
  • Rated for 200 psi and 200 °F maximum operating conditions
  • Compact 4 1/2 in length fits tight plumbing spaces
  • California Proposition 65 warning applies to this fitting

Specifications

BrandSHARKBITE

Questions about this item

Will the 3/8 in push-fit end connect to my existing copper pipe without soldering?

Yes, the push-to-connect design joins 3/8 in tube directly without solder, flux or special tools.

How do I confirm the coupling is sealed once installed?

Press each tube fully into the fitting until it stops; the internal grab ring and O-ring create a watertight seal you can pressure-test to 200 psi.

Does the brass coupling come with thread sealant or must I buy it separately?

Pre-applied thread sealant is not included, so no extra sealant is required for the push-fit connections.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.